2007 Ford Taurus Owners Manual

Driver Controls
Not e:  If the  indicator  light  blinks  rapidly  for two  seconds   and then   turns
to  a continuous   red,  proceed   with Steps   6 through   8 to  complete
programming   of a rolling  code  equipped   device.
6.
At  the  garage  door  opener  receiver  (motor-head    unit)  in  the  garage,
locate  the  “learn”  or “smart”  button   (usually  near  where  the  hanging
antenna   wire is  attached   to  the  unit) .
7.
Press  and  release  the   “learn” or  “smart”  button.  (The  name   and color
of the  button   may vary  by  manufacturer.)
Not e:  There  are  30 seconds   in which  to  initiate  Step  8.
8.
Return  to  the  vehicle  and  firmly press,   hold for  two  seconds  and
release  the  HomeLink௡  button.   Repeat  the  press/hold/release    sequence
again,  and,  depending  on  the  brand  of  the  garage  door  opener  (or  other
rolling  code equipped   device) ,  repeat  this  sequence   a  third  time  to
complete  the   programming.
HomeLink௡  should  now activate   your  rolling code  equipped   device.  To
program  additional   HomeLinkbuttons   begin  with  Step  2 in  the
“Programming”  section.  For  questions   or  comments,  please   contact
HomeLink  at www.home  lin k.com  or   1–800–355–3515.
Gate Operator & Canadian  Programming
During  programming,  your
hand-held   transmitter   may
automatically   stop  transmitting   —
not  allowing enough   time  for
HomeLink௡  to accept   the  signal
from  the  hand-held  transmitter.
After  completing  Steps  1  and  2
outlined  in  the  “Pr ogrammin  g”
section,  replace   Step  3 with  the  following:
Not e:  If programming   a garage  door  opener  or  gate  operator,   it is
advised  to  unplug  the  device  during  the  “cycling” process   to prevent
overheating.
Continue  to  press  and  hold  the  HomeLink௡  button  (note   Step  3 in  the
“Programming”  section)   while you  press  and  release   — every  two
se con ds (“cycle”)   your hand-held   transmitter    until  the  frequency
signal  has been   accepted  by  the  HomeLink.  The  indicator  light  will
flash  slowly and  then  rapidly  after  HomeLink௡  accepts   the  radio
frequency   signal.
Proceed   with Step  4  in the  “Programming”   section.
51
2007
Taurus (tau)
Owners Guide (post-2002-fmt)
USA (fus)
Product Specification
CategoriesFord Manuals, Ford Taurus Manuals
Model Year2007
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 232 pages
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field