204_AKB;
d2ureepe,
3; 69, en-US
2009-05-11T16:20:59+02:00 - Seite 217
Version: 2.11.8.1
Useful features
217
Do not hold the buttons for longer than
and reverse features as required by U.S.
federal safety standards (this includes any
garage door opener model manufactured
before April 1, 1982). A garage door that
cannot detect an object - signaling the door
to stop and reverse - does not meet current
U.S. federal safety standards.
30
seconds.
This procedure erases any previous
settings for all three channels and
initializes the memory. If you later wish to
program a second and/or third hand-held
transmitter to the remaining two signal
transmitter buttons, do not repeat this step
and begin directly with step 3.
When programming a garage door opener,
park vehicle outside the garage.
X Step 3: Hold the end of hand-held remote
controlA of the device you wish to train
approximately 2 to 12 in (5 to 30 cm) away
from the signal transmitter button (;,=
or?) to be programmed, while keeping
indicator lamp: in view.
Do not run the engine while programming the
integrated remote control. Inhalation of
exhaust gas is hazardous to your health. All
exhaust gas contains carbon monoxide (CO),
and inhaling it can cause unconsciousness
and possible death.
X Step 4: Using both hands, simultaneously
press hand-held remote control buttonB
and the desired signal transmitter button
(
;,= or?). Do not release the buttons
until step 5 is completed.
Indicator lamp: will flash, first slowly and
then rapidly.
i Indicator lamp: flashes immediately
the first time the signal transmitter button
is programmed. If this button has already
been programmed, the indicator lamp will
start flashing after 20 seconds.
Interior rear view mirror with integrated remote
control
X Step 5: After indicator lamp: changes
Hand-held remote controlA is not part of the
vehicle equipment.
from a slow to a rapidly flashing light,
release the hand-held remote control
button and the signal transmitter button.
X Step 6: Press and hold the just-trained
signal transmitter button (;,= or?) and
observe indicator lamp:.
Programming the integrated remote
control
X Step 1: Switch on the ignition.
X Step 2: If you have previously programmed
a signal transmitter button and wish to
retain its programming, proceed to step 3.
If indicator lamp: stays on constantly,
programming is complete and your device
should activate when the respective signal
transmitter button (;,= or?) is pressed
and released.
or
X If you are programming the integrated
remote control for the first time, press and
hold the two outer signal transmitter
buttons; and? and release them when
indicator lamp: begins to flash after
approximately 20 seconds.
i If indicator lamp: flashes rapidly for
approximately 2 seconds and then turns to
a constant light, continue with
programming steps 8 through 12 as your
Z
| Categories | Mercedes-Benz C-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz C-Class, Mercedes-Benz C250, Mercedes-Benz C300, Mercedes-Benz C350, Mercedes-Benz C63 AMG, Mercedes-Benz W204 |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(3 votes, average: 4.67 out of 5)
Automotive readers have rated 2010 Mercedes-Benz C-Class Operators Manual C250 C300 4MATIC C350 Sport C63 AMG 4.7 out of 5.0 based on 3 product reviews. Really enjoy the ride though it’s my first Mercedes car . Have used other cars like VW touareg , Audi and Bmw but never owned a Mercedes so it’s exciting for me
it is very good
really excellent
Great