204_AKB;
d2ureepe,
3; 69, en-US
2009-05-11T16:20:59+02:00 - Seite 318
Version: 2.11.8.1
Flat tire
318
not exceed a vehicle speed of 50 mph
Mounting the spare wheel
Introduction
(80
km/h).
Contact the nearest authorized Mercedes-
Benz Center as soon as possible to have the
spare wheel replaced with a regular road
wheel.
X Prepare the vehicle as described
(Y page 318).
X Take the following out of the vehicle:
Never operate the vehicle with more than one
spare wheel mounted.
Rspare wheel
Rjack
Do not switch off the ESP® when a spare
wheel is mounted.
Rvehicle tool kit box
For information on where to find the
respective items, see “Where will I find ...?”
(Y page 268) and (Y page 270).
Preparing the vehicle
X Whenever possible, park the vehicle in a
safe distance from moving traffic on a hard,
flat surface.
i Vehicles without spare wheel are not
factory-equipped with the tools required for
a wheel change such as a jack or a wheel
wrench. Some tools required for a wheel
change are specific to your vehicle.
Contact an authorized Mercedes-Benz
Center to obtain the tools approved for
your vehicle. This section describes the
wheel change using the tools approved and
recommended for your vehicle.
X Turn on the hazard warning flasher.
X Turn the steering wheel so that the front
wheels are in a straight-ahead position.
X Engage the parking brake.
X Shift the automatic transmission into park
position P (manual transmission to 1st or
reverse gear R).
X Turn off the engine.
X Remove the SmartKey from the starter
switch.
Lifting the vehicle
G Warning!
When jacking up the vehicle, only use the jack
which has been specifically approved by
Mercedes-Benz for your vehicle.
or
X Vehicles with KEYLESS-GO: Open the
driver’s door (this puts the starter switch in
position 0, same as with the SmartKey
removed from the starter switch). The
driver’s door can then be closed again.
Open doors only when conditions are safe
to do so.
X Vehicles with KEYLESS-GO: Remove the
KEYLESS-GO start/stop button from the
starter switch.
The jack is designed exclusively for jacking up
the vehicle at the jack take-up brackets built
into both sides of the vehicle. Make sure the
jack arm is fully seated in the jack take-up
bracket. The jack must always be vertical
when in use, especially on inclines or
declines.
The jack is intended only for lifting the vehicle
briefly for wheel changes. It is not suited for
performing maintenance work under the
vehicle. To help avoid personal injury, use the
jack only to lift the vehicle during a wheel
change.
X Have any passenger exit the vehicle at a
safe distance from the roadway. Open
doors only when conditions are safe to do
so.
Never get beneath the vehicle while it is
supported by the jack. Keep hands and feet
| Categories | Mercedes-Benz C-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz C-Class, Mercedes-Benz C250, Mercedes-Benz C300, Mercedes-Benz C350, Mercedes-Benz C63 AMG, Mercedes-Benz W204 |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(3 votes, average: 4.67 out of 5)
Automotive readers have rated 2010 Mercedes-Benz C-Class Operators Manual C250 C300 4MATIC C350 Sport C63 AMG 4.7 out of 5.0 based on 3 product reviews. Really enjoy the ride though it’s my first Mercedes car . Have used other cars like VW touareg , Audi and Bmw but never owned a Mercedes so it’s exciting for me
it is very good
really excellent
Great