To do so:
5.
6.
Press the button on the receiver of the de‐
vice to be set. You have approx. 30 seconds
for the next step.
▷
Read the instructions of the hand-held
transmitter.
Press the programmed memory button of
the universal remote control three times.
▷
Press the memory button of the universal
remote control for an extended period.
The device can be operated when the engine is
running or the ignition is switched on.
If the LED flashes rapidly for a brief period and
then lights up continuously for approx. 2 sec‐
onds, the hand-held transmitter is equipped
with an alternating code system.
Reassigning individual programs
1.
2.
Switch on the ignition.
In this case, program the memory buttons as
described under Alternating-code hand-held
transmitters.
Hold the hand-held transmitter a distance of
approx. 2 to 8 in/5 to 20 cm from the memory
buttons.
Alternating-code hand-held
transmitters
3.
4.
Press the memory button of the universal
remote control.
Please obtain information on synchronizing the
device in the operating manual of the device be‐
ing set up.
If the LED flashes slowly after approx.
20
seconds, press the transmit button on
the hand-held transmitter.
Programming will be easier with the aid of a sec‐
ond person.
5.
Release both buttons when the LED flashes
rapidly.
1.
Park the vehicle within range of the remote-
controlled device.
If the LED does not flash rapidly after approx.
15 seconds, change the distance and repeat
the step.
2.
Program the universal remote control as de‐
scribed above under Fixed-code hand-held
transmitters.
Deleting all stored programs
Press the left and right memory buttons for ap‐
prox. 20 seconds until the LED flashes rapidly.
3.
Press and hold the programmed button on
the interior rearview mirror for approx. 5 sec‐
onds until the device to be adjusted is acti‐
vated.
All stored programs are deleted.
The programs cannot be deleted individually.
If the device does not become activated,
press and hold the button and watch the
LED:
Lighter*
▷
If the LED lights up continuously, the
programming is completed. The device
should become activated when the but‐
ton is pressed briefly.
Danger of burns
Only hold the hot lighter by its head; oth‐
erwise, there is the danger of getting burned.
Switch off the ignition and take the remote con‐
trol with you when leaving the vehicle so that
children cannot use the lighter and burn them‐
selves.◀
▷
If the LED flashes for approx. 2 seconds
and then lights up continuously, con‐
tinue the programming procedure be‐
ginning with step 4.
4.
Locate the button on the receiver of the de‐
vice to be set, e.g., on the drive.
108
Online Edition for Part no. 01 40 2 606 190 - 12 10 500
| Categories | BMW Manuals, BMW X3 Manuals |
|---|---|
| Tags | BMW F25, BMW X3 xDrive28, BMW X3 xDrive35 |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)