What to do if...
▷
▷
▷
It may not be possible to display phone book
entries with special characters.
Information on suitable mobile phones, refer to
page 176.
The number of phone book entries being
stored is too high.
The mobile phone could not be paired or con‐
nected.
Is the data volume of the contact too large,
e.g., due to stored information such as
notes? Reduce the data volume of the con‐
tact.
▷
Is Bluetooth activated in the vehicle and on
the mobile phone? Activate Bluetooth in the
vehicle and on the mobile phone.
▷
Is the mobile phone connected as an audio
source or additional telephone? The mobile
phone must be connected as a telephone.
▷
Do the Bluetooth passkeys on the mobile
phone and the vehicle match? Enter the
same passkey on the mobile phone and via
iDrive.
The phone connection quality is poor.
▷
▷
Did it take longer than 30 seconds to enter
the passkey? Repeat the pairing procedure.
▷
▷
▷
The strength of the Bluetooth signal on the
mobile phone can be adjusted, depending
on the mobile phone.
Are too many Bluetooth devices connected
to the mobile phone or vehicle? Delete con‐
nections with other devices if necessary.
Insert the mobile phone into the snap-in
adapter* or place it in the area of the center
console.
▷
▷
Is the audio connection activated? Deacti‐
vate the audio connection.
Adjust the volume of the microphone and
loudspeakers separately.
Is the mobile phone in power-save mode or
does it have only a limited remaining battery
life? Charge the mobile phone in the snap-
in adapter* or via the charging cable.
If all points in this list have been checked and the
required function is still not available, please
contact the hotline or service center.
▷
▷
Depending on the mobile phone, it is possi‐
ble that only one device can be connected
to the vehicle. Unpair the connected device
from the vehicle and pair and connect only
one device.
Controls
Adjusting the volume
The mobile phone no longer reacts? Switch
the mobile phone off and on again. Repeat
the pairing procedure.
Turn the knob until the desired volume is se‐
lected. The setting is stored for the remote con‐
trol currently in use.
The telephone functions are not available.
The vehicle automatically adjusts the volume of
the microphone on the telephone and the vol‐
ume of the called party. Depending on the mo‐
bile phone, the volumes may need to be ad‐
justed. The settings can only be created during
a call and must be adjusted separately for each
telephone. The settings are deleted when the
telephone is unpaired.
▷
Is the mobile phone paired as an additional
telephone and is the additional telephone
function deactivated? Activate the function.
▷
Is an outgoing call not possible? Connect
the mobile phone as a telephone.
No or not all phone book entries are displayed,
or they are incomplete.
1.
2.
3.
4.
"Settings"
▷
Transmission of the phone book entries is
not yet complete.
"Tone"
"Volume settings"
▷
It is possible that only the phone book en‐
tries of the mobile phone or the SIM card*
are transmitted.
Select the desired setting: "Microphone" or
"Loudspeak."
179
Online Edition for Part no. 01 40 2 606 190 - 12 10 500
| Categories | BMW Manuals, BMW X3 Manuals |
|---|---|
| Tags | BMW F25, BMW X3 xDrive28, BMW X3 xDrive35 |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)