Tyre repair kit
USING THE TYRE REPAIR KIT
REPAIR PROCEDURE
Avoid skin contact with the sealant
which contains natural rubber latex.
Check the tyre sidewall prior to
inflation. If there are any cracks,
bumps or similar damage, do not
attempt to inflate the tyre. Do not
stand directly beside the tyre while
the compressor is pumping. Watch the
tyre sidewall. If any cracks, bumps or
similar damage appear, turn off the
compressor and let the air out by
means of the pressure relief valve. Do
not continue to use the tyre.
If the tyre inflation pressure does not
reach 1.8 bar (26 psi, 180 kPa) within
seven minutes, the tyre may have
suffered excessive damage. A
temporary repair will not be possible,
and the vehicle should not be driven
until the tyre has been replaced.
Before attempting a tyre repair, ensure
that the vehicle is parked safely, as far
away from passing traffic as possible.
1.
Open the tyre repair kit and peel off the
maximum speed label. Attach the label to
the facia in the driver's field of vision. Take
care not to obstruct any of the instruments
or warning lights.
Ensure that the parking brake is applied
and P (Park) is selected.
Do not attempt to remove foreign
objects such as nails, screws, etc. from
the tyre.
2.
3.
4.
Uncoil the compressor power cable and
the inflation hose.
Always run the engine when using the
compressor, unless the vehicle is in an
enclosed or poorly ventilated space, as
this may cause asphyxiation.
Unscrew the orange cap from the sealant
bottle receiver and the sealant bottle cap.
Screw the sealant bottle into the receiver
(clockwise) until tight.
Screwing the bottle onto the receiver
will pierce the bottle's seal. Once the
bottle has been fitted, a ratchet
To prevent overheating, do not operate
the compressor continuously for longer
than ten minutes.
•
Note: All vehicle drivers and occupants should
be made aware that a temporary repair has
been made to a tyre fitted to the vehicle. They
should also be made aware of the special
driving conditions imposed when using a
repaired tyre.
prevents it from being removed.
5.
Remove the valve cap from the damaged
tyre.
6. Remove the protective cap from the
inflation hose and connect the inflation
hose to the tyre valve. Ensure that the hose
is screwed on firmly.
7.
Ensure that the compressor switch is in the
off (0) position.
8.
Insert the power cable connector into the
auxiliary power socket. See 65, STORAGE
COMPARTMENTS.
9.
Unless the vehicle is in an enclosed area,
start the engine.
167
| Categories | Land Rover, Land Rover Discovery 4 |
|---|---|
| Tags | Land Rover |
| Model Year | 2012 |
| Download File |
|
| Language | Bulgarian, English |
| Product Name | Discovery 4 Handbook |
| Product Brand | Land Rover |
| Applicable to Country | Bulgaria, International |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)