Fluid level checks
TOPPING UP THE OIL
Your vehicle warranty may be
invalidated if damage is caused by
using oil that does not meet the
required specification.
Failure to use an oil that meets the
required specification could cause
excessive engine wear, a build up of
sludge and deposits, and increase
pollution. It could also lead to engine
failure.
Overfilling with oil could result in severe
engine damage. Oil should be added in
small quantities and the level
re-checked to ensure that the engine is
not overfilled.
An indication of the oil level is displayed in the
gauge. Messages to the right of the gauge
advise you of any action you may need to take.
1.
Remove the oil filler cap.
2. Add oil as instructed by the dipstick display
Diesel and V8 Petrol engines) or to
(3.0
If the oil level is within the required operating
range, the message Engine Oil Level OK will
be displayed. Do not add any additional oil to
the engine.
maintain the level between the MIN and
MAX marks or notches on the dipstick (2.7
Diesel engine).
3.
Clean up any oil spilled during topping-up.
If the oil level is below the required operating
range, a message advising you how much oil to
add will be displayed (e.g. Add 0.5 Litre). Add
the recommended quantity of oil.
4. Check the oil level again after 10 minutes
(3.0 Diesel and V8 Petrol engines) or after
5 minutes (2.7 Diesel engine).
If the message Engine Oil Level Overfilled is
displayed, seek qualified assistance
immediately. Do not drive the vehicle as this
will cause serious damage to the engine.
It is essential to use the correct specification
oil, and to ensure it is suitable for the climatic
conditions in which the vehicle is to be
operated.
If the message Engine Oil Level Underfilled is
displayed, add 1.5 litres (2.6 pints) of oil, then
recheck the level.
Note: The approximate quantity of oil required
to raise the level from MIN to MAX on the
dipstick is 1.5 litres (2.6 pints) for all models.
If the message Engine Oil Level Not Available
is displayed, the oil level is stabilising. Switch
off the ignition, wait 10 minutes, then recheck
the oil level display
If the warning message ENGINE OIL LEVEL
MONITOR SYSTEM FAULT is displayed, seek
qualified assistance.
194
| Categories | Land Rover, Land Rover Discovery 4 |
|---|---|
| Tags | Land Rover |
| Model Year | 2012 |
| Download File |
|
| Language | Bulgarian, English |
| Product Name | Discovery 4 Handbook |
| Product Brand | Land Rover |
| Applicable to Country | Bulgaria, International |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)