Vehicle battery
3.
4.
Connect one end of the negative (Black)
booster cable to the negative terminal on
the donor vehicle's battery.
3. Start the engine and allow it to idle.
4.
Disconnect the negative (Black) booster
cable from the battery terminal of the
vehicle.
Connect the other end of the negative
booster cable to a suitable earth point on
the disabled vehicle. The earth point should
be at least 0.5 metres (20 inches) away
from the battery, and as far as possible
from any fuel or brake pipes.
5.
Disconnect the positive (Red) booster
cable from the battery terminal of the
vehicle.
REMOVING THE VEHICLE BATTERY
Note: Check that all cables are clear of any
moving components, and that all four
connections are secure.
Switch the ignition off before
disconnecting battery terminals.
Always disconnect the negative
terminal first and reconnect last.
5.
6.
Start the engine of the donor vehicle, and
allow it to idle for a few minutes.
Use caution when lifting the battery
out of, or into, the vehicle. It is heavy,
and may cause injury when lifting, or
if dropped.
Start the engine of the disabled vehicle.
Note: Do not switch on any electrical
circuits on the previously disabled vehicle
until after the booster cables have been
removed.
Do not tip the battery when lifting or
moving as tilting the battery more
than 45 degrees may damage the
battery, and may cause the electrolyte
to leak out. Battery electrolyte is
highly corrosive, and toxic.
7.
Allow both vehicles to idle for a few
minutes.
8.
9.
Switch off the donor vehicle.
Disconnect the negative (Black) booster
cable from the previously disabled vehicle.
Do not rest the battery on any part of
the vehicle as it may cause damage due
to its weight.
10.
11.
12.
Disconnect the negative (Black) booster
cable from the battery of the donor vehicle.
Do not run the engine with the battery
disconnected. Doing so may damage
the charging system.
Disconnect the positive (Red) booster
cable from the previously disabled vehicle.
Disconnect the positive (Red) booster
cable from the donor vehicle.
1.
2.
Ensure that all electrical circuits are
switched off, all windows are closed, and
the alarm is disarmed.
CONNECTING A STARTING AID
To start the vehicle using a starting aid or a
slave battery, follow the instructions in the
sequence given.
Remove the remote control from the
vehicle and wait two minutes to allow the
systems to power down fully.
3.
4.
Undo the negative clamp, and lift the cable
and clamp clear of the battery terminal.
1.
Connect the positive (Red) booster cable to
the positive battery terminal of the disabled
vehicle.
Undo the positive clamp, and lift the cable
and clamp clear of the battery terminal.
2.
Connect the negative (Black) booster cable
to the ground (-) terminal of the battery.
209
| Categories | Land Rover, Land Rover Discovery 4 |
|---|---|
| Tags | Land Rover |
| Model Year | 2012 |
| Download File |
|
| Language | Bulgarian, English |
| Product Name | Discovery 4 Handbook |
| Product Brand | Land Rover |
| Applicable to Country | Bulgaria, International |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)