Garage door opener
5.
Press and hold the programmed garage
door opener button and observe the
indicator lamp.
ROLLING CODE DEVICE EQUIPMENT
PROGRAMMING
Note: The assistance of a second person, may
make the following steps quicker and easier.
Once the button has been pressed there are
only 30 seconds in which to complete Step 3.
•
If the indicator is continuous,
programming is complete and your
device should operate when the garage
door opener button is pressed and held
for approximately 1 to 2 seconds and
then released.
1.
At the garage door opener receiver (motor
head unit) in the garage, locate the learn or
smart button/switch.
•
If the indicator lamp blinks rapidly for
two seconds and then illuminates
continuously, proceed with the
•
The name of the button or switch may
vary between manufacturers.
following programming instructions
for rolling code device equipment.
2. Press and release the learn or smart
button.
3.
4.
Return to the vehicle and firmly press and
hold the programmed garage door opener
button for two seconds and release.
TO ERASE ALL PROGRAMMING
For first time programming, ensure that the
engine is switched off:
Repeat the press, hold, release sequence
three times to complete the programming
process.
1.
Ensure that the ignition is on (but with the
engine switched off).
2.
Press and hold the two outer buttons on
the transceiver in the rear-view mirror.
Keep the buttons pressed until the
indicator lamp begins to flash (this will take
approximately 20 seconds), then release
the buttons.
The garage door opener in the rear-view mirror
should now activate the rolling code device.
REPROGRAMMING A SINGLE
GARAGE DOOR OPENER BUTTON
To programme a device to a previously
programmed button:
All memories in the garage door opener have
now been cleared.
1.
Press and hold the desired
Note: Do not perform this procedure when
programming the additional garage door
opener buttons.
pre-programmed garage door opener
button for at least 20 seconds, but no
longer than 30 seconds, until the indicator
lamp begins to flash.
2.
Without releasing the rear-view mirror
button, position the hand-held transmitter
approximately 50 to 150 mm (2 to
6
rear-view mirror, keeping the indicator
lamp in view.
inches) away from the transceiver in the
3.
Carry out Step 3 of Programming.
50
| Categories | Land Rover, Land Rover Discovery 4 |
|---|---|
| Tags | Land Rover |
| Model Year | 2012 |
| Download File |
|
| Language | Bulgarian, English |
| Product Name | Discovery 4 Handbook |
| Product Brand | Land Rover |
| Applicable to Country | Bulgaria, International |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)