L
Garagedooropener
4.
If, after 60 seconds, the indicator lamp does
not flash rapidly, release both the
transceiver and the hand-held transmitter
buttons and repeat the procedure starting
with Step 2. Position the hand-held
transmitter at a different angle and/or
distance.
ROLLING CODE DEVICE EQUIPMENT
PROGRAMMING
Note: The assistance of a second person, may
make the following steps quicker and easier.
Once the button has been pressed there are only
30
seconds in which to complete Step 3.
1.
At the garage door opener receiver (motor
head unit) in the garage, locate the learn or
smart button/switch.
5.
Press and hold the programmed garage
door opener button and observe the
indicator lamp.
•
The name of the button or switch may
vary between manufacturers.
•
If the indicator is continuous,
programming is complete and your
device should operate when the garage
door opener button is pressed and held
for approximately 1 to 2 seconds and
then released.
2. Press and release the learn or smart button.
3.
Return to the vehicle and firmly press and
hold the programmed garage door opener
button for 2 seconds and release.
•
If the indicator lamp blinks rapidly for
4.
Repeat the press, hold, release sequence 3
times to complete the programming
process.
2
seconds and then illuminates
continuously, proceed with the
following programming instructions for
rolling code device equipment.
The garage door opener in the rear-view mirror
should now activate the rolling code device.
TO ERASE ALL PROGRAMMING
REPROGRAMMING A SINGLE GARAGE
DOOR OPENER BUTTON
For first time programming, make sure the
engine is switched off:
To programme a device to a previously
programmed button:
1.
Make sure the ignition is on (but with the
engine switched off).
1.
Press and hold the desired pre-programmed
garage door opener button for at least 20
seconds, but no longer than 30 seconds,
until the indicator lamp begins to flash.
2.
Press and hold the 2 outer buttons on the
transceiver in the rear-view mirror. Keep
the buttons pressed until the indicator lamp
begins to flash (this will take approximately
2.
Without releasing the rear-view mirror
button, position the hand-held transmitter
approximately 50 to 150 mm (2 to 6 inches)
away from the transceiver in the rear-view
mirror, keeping the indicator lamp in view.
20
seconds), then release the buttons.
All memories in the garage door opener have
now been cleared.
Note: Do not perform this procedure when
programming the additional garage door opener
buttons.
3.
Carry out Step 3 of Programming.
68
XML to PDF by RenderX XEP XSL-FO Formatter, visit us at http://www.renderx.com/
| Categories | Land Rover, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 2014, 2015 |
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Name | Range Rover Handbook |
| Product Brand | Land Rover |
| Applicable to Country | Bulgaria, International |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(1 votes, average: 3 out of 3)
Automotive readers have rated 2014-2015 Land Rover Range Rover Handbook Manual 3.0 out of 3.0 based on 1 product reviews. I stopped to buy fuel. On shifting to D to move, my range rover could not move, but low gear light continued to blink. The low gear button remained stiff. What is wrong?