126
Chapter 2
III - MANAGEMENT OF WIPER PARKED POSITIONS
Function:
CONDITION
FUNCTION
Ignition on
When the wipers are switched off, all
wipe cycles in progress are completed.
The wipers are systematically returned to
the parked position at slow speed.
When the ignition is switched off
When the ignition is switched on
The windscreen or rear wipers stop
immediately, regardless of the position of
the wipers and the wiper stalk at the
steering wheel.
If the wipers are not in the parked
position, the BSI controls the wiper
motors at slow speed until the wipers are
in the parked position.
IV - WIPER PROTECTION
Function:
The BSI is used to protect the windscreen and rear wiper motors against
overheating in the event of the wipers being blocked, regardless of the operating
mode requested by the user. The controls are stopped if there has not been a
change in the value of the parked position after a certain time.
V - DE-ICING
Function:
When the engine is running (and alternator charging), to de-ice the heated rear
screen and the door mirrors, depending on vehicle equipment.
To protect the relay, when the voltage exceeds 15 volts, the de-icing request is no
longer taken into account.
MULTIPLEXED BSI - XSARA PICASSO AND XSARA – PART 6
©
AUTOMOBILES CITROËN Toute reproduction ou traduction même partielle sans l'autorisation écrite d'AUTOMOBILES CITROËN est interdite et constitue une contrefaçon
| Categories | Citroën Manuals, Citroën Picasso Manuals, Citroën Xsara Manuals |
|---|---|
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)