189
Chapter 3
D - SPECIFIC OPERATIONS
IMPORTANT: When fitting an after-sales alarm, the BSI must be
programmed to prevent the indicators from being controlled
when the doors are locked/unlocked. In this case, the alarm
controls signalling.
Opening the vehicle with the key:
If the vehicle is opened using the key, the alarm is triggered. To disarm the
alarm, the following procedure must be performed: enter the "EMERGENCY
CODE".
Entering the "EMERGENCY CODE":
A 5 figure code is given on a card supplied with the alarm system. Example:
43125.
STEP
ACTION
EFFECT
1
Open the door.
The siren is set off.
2
3
4
5
Switch on the ignition.
Switch off the ignition immediately.
Switch on the ignition immediately.
Allow the LED to flash 4 times (1st figure of
the code).
6
Switch off the ignition.
The siren stops.
Repeat the procedure from step 2 to step 6 for the other 4 figures. If the code
is recognised, the alarm is disarmed.
MULTIPLEXED BSI - XSARA PICASSO AND XSARA – PART 9
©
AUTOMOBILES CITROËN Toute reproduction ou traduction même partielle sans l'autorisation écrite d'AUTOMOBILES CITROËN est interdite et constitue une contrefaçon
| Categories | Citroën Manuals, Citroën Picasso Manuals, Citroën Xsara Manuals |
|---|---|
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)