WHAT TO DO IN AN EMERGENCY
D060E01A-AAT
D060F02E-AAT
D060G02Y-AAT
4.
Put the Jack in Place
5. Raising the Car
6. Changing Wheels
Wrench bar
Wheel nut wrench
HGK186
HFC4022
HGK232
The base of the jack should be placed on firm,
level ground. The jack should be positioned as
shown in the drawing.
After inserting a bar into the wheel nut wrench,
install the bar into the jack as shown in the
drawing.Toraisethevehicle,turnthejackhandle
clockwise. As the jack begins to raise the ve-
hicle, double check that it is properly positioned
and will not slip. If the jack is on soft ground or
sand, place a board, brick, flat stone or other
object under the base of the jack to keep it from
sinking.
Loosen the wheel nuts and remove them with
yourfingers.Slidethewheeloffthestudsandlay
it flat so it cannot roll away. To put the wheel on
the hub, pick up the spare tire, line up the holes
with the studs and slide the wheel onto them. If
this is difficult, tip the wheel slightly and get the
top hole in the wheel lined up with the top stud.
Then jiggle the wheel back and forth until the
wheel can be slid over the other studs.
Raise the car high enough so that the fully
inflatedsparetirecanbeinstalled.Todothis,you
willneedmoregroundclearancethanisrequired
to remove the flat tire.
WARNING:
Donotgetunderthecarwhenitissupported
bythejack!Thisisverydangerousasthejack
could fall and cause serious injury or death.
Nooneshouldstayinthecarwhilethejackis
beingused.
3-6
| Categories | Hyundai Manuals, Hyundai Coupe Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Coupe |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)