Controls in detail
Useful features
୴
୴
i
Gate operator/Canadian programming
̈ While still holding down the signal
transmitter button (2, 3 or 4),
“cycle” your hand-held remote control
button 6 as follows: Press and hold
button 6 for 2 seconds, then release
it for 2 seconds, and again press and
hold it for 2 seconds. Repeat this se-
quence on the hand-held remote con-
trol until the frequency signal has been
learned. Upon successful training, the
indicator lamp 1 will flash slowly and
then rapidly after several seconds.
Some garage door openers (or other
rolling code equipped devices) may
require you to press, hold for 2 seconds
and release the same signal transmit-
ter button a third time to complete the
training process.
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the
integrated signal transmitter to pick up the
signal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner.
Step 12:
̈
Confirm the garage door operation by
pressing the programmed signal trans-
mitter button (2, 3 or 4).
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4
with the following:
̈
Proceed with programming step 5 and
step 6 to complete.
Step 13:
̈
To program the remaining two signal
transmitter buttons, repeat the steps
above starting with step 3.
Step 4:
̈
Press and hold the signal transmitter
button (2, 3 or 4). Do not release
this button until it has been successful-
ly trained.
300
| Categories | Mercedes-Benz CLK-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz CLK350, Mercedes-Benz CLK500, Mercedes-Benz CLK55 AMG, Mercedes-Benz W209 |
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)