Controls in detail
Useful features
Erasing the integrated remote control
memory
Programming tips
ț
While performing step 3, hold the
hand-held remote control 6 at differ-
ent lengths and angles from the signal
transmitter button (2, 3 or 4) you
are programming. Attempt varying an-
gles at the distance of 2 to 5 inches
If you are having difficulty programming
the integrated remote control, here are
some helpful tips:
̈
̈
Switch on the ignition (୴ page 36).
Simultaneously press and hold down
the outer signal transmitter buttons 2
and 4, for approximately 20 seconds,
until the indicator lamp 1 flashes rap-
idly. Do not hold for longer than
ț
Check the frequency of the hand-held
remote control 5 (typically located on
the reverse side of the remote). The in-
tegrated remote control is compatible
with radio-frequency devices operating
between 288-399 MHz.
(5
to 12 cm) away or the same angle at
varying distances.
ț
ț
If another hand-held remote control is
available for the same device, try the
programming steps again using that
other hand-held remote control. Make
sure new batteries are in the hand-held
remote control before beginning the
procedure.
30
seconds.
The codes of all three channels are
erased.
ț
Put a new battery in the hand-held re-
mote control 5. This will increase the
likelihood of the hand-held remote con-
trol sending a faster and more accurate
signal to the integrated remote control.
i
If you sell your vehicle, erase the codes
of all three channels.
Straighten the antenna wire from the
garage door opener assembly. This
may help improve transmitting and/or
receiving signals.
302
| Categories | Mercedes-Benz CLK-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz CLK350, Mercedes-Benz CLK500, Mercedes-Benz CLK55 AMG, Mercedes-Benz W209 |
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)