251_AKB;
d2ureepe,
4; 52, en-US
2009-03-23T09:22:52+01:00 - Seite 326
Version: 2.11.8.1
Flat tire
326
X On the wheel to be changed, loosen but do X Attach reversible ratchet? to jack=
in
not yet remove the wheel bolts
(approximately one full turn with wheel
wrench:).
such a way that the word UP can be seen.
X Place jack= on firm ground.
X Position jack= under take-up
bracket; so that it is always vertical as
seen from the side, even if the vehicle is
parked on an incline.
X Assemble the jack (Y page 272).
The jack take-up brackets are located directly
behind the front wheel housings and in front
of the rear wheel housings.
X Turn ratchet? up and down until jack=
is fully seated in take-up bracket; and the
jack base evenly meets the ground.
X Jack up the vehicle until the wheel is a
maximum of 1.2 in (3 cm) from the ground.
G Warning!
The jack is designed exclusively for jacking up
the vehicle at the jack take-up brackets. Make
sure the jack arm is fully seated in the jack
take-up bracket.
If you do not position the jack correctly in the
jack take-up bracket, the vehicle can fall off
the jack and seriously or fatally injure you or
others.
!
Do not position the jack on the body of
the vehicle, as this may cause damage to
the vehicle.
| Categories | Mercedes-Benz Manuals, Mercedes-Benz R-Class Manuals |
|---|---|
| Tags | Mercedes Benz R350, Mercedes Benz R350 BlueTEC, Mercedes Benz V251 |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)