251_AKB;
d2ureepe,
4; 52, en-US
2009-03-23T09:22:52+01:00 - Seite 51
Version: 2.11.8.1
Occupant safety
51
Seat belt adjustment function
6 seconds to remind you and your passengers
to fasten your seat belts.
The seat belt adjustment function adjusts the
seat belts on both front seats to the upper
body of the respective vehicle occupant. The
seat belt will be pulled slightly tighter for that
purpose when
If the driver’s seat belt is not fastened when
the engine is started, an additional warning
chime will sound. The warning chime goes out
after approximately 6 seconds or once the
driver’s seat belt is fastened.
If after these 6 seconds the driver’s or the
front passenger’s seat belt (with the front
passenger seat occupied) is not fastened with
front doors closed,
Ryou engage the latch plate into the buckle
and then turn the SmartKey in the starter
switch to position 2
Rthe SmartKey in the starter switch is in
position 2 and you then engage the latch
plate in the buckle
Rthe seat belt telltale7 remains
illuminated for as long as either the driver’s
or front passenger’s seat belt is not
fastened.
The seat belt adjustment function takes place
with a certain amount of retracting force
when the system senses slack between the
vehicle occupant and the seat belt. Do not
retain the seat belt during this procedure. You
can activate or deactivate the seat belt
adjustment function via the control system
Rand if the vehicle speed once exceeds
15
7
mph (25 km/h), the seat belt telltale
starts flashing and a warning chime
sounds with increasing intensity for a
maximum of 60 seconds or until the
driver’s and front passenger’s seat belt are
fastened.
If you and/or your passenger release the
seat belt during driving, the seat belt
telltale7 starts flashing and the
warning chime sounds as described before.
If the driver’s or the front passenger’s seat
belt remains unfastened after 60 seconds,
the warning chime stops sounding, the seat
belt telltale7 stops flashing but
continues to be illuminated.
(
Y page 138).
Releasing the seat belts
X Press seat belt release button?
(
Y page 50).
Allow the retractor to completely rewind
the seat belt by guiding latch plate;
(
Y page 50).
!
Make sure the seat belt retracts
completely. Otherwise the seat belt and/or
latch plate could get caught or pinched in
the door or in the seat mechanism. This can
damage the seat belt and impair its
effectiveness, and/or cause damage to the
door and/or door trim panel. Such damage
is not covered by the Mercedes-Benz
Limited Warranty.
After a vehicle standstill, the warning chime
is reactivated and the seat belt telltale
7
is flashing again if the vehicle speed
once exceeds 15 mph (25 km/h).
The seat belt telltale7 will only go out if
both the driver’s and the front passenger’s
seat belt (with the front passenger seat
occupied) are fastened, or the vehicle is
standing still and a front door is opened.
Damaged seat belts must be replaced.
Contact an authorized Mercedes-Benz
Center.
For more information, see “Practical hints”
Enhanced seat belt reminder system
(
Y page 302).
When the engine is started, the seat belt
telltale7 will always illuminate for
Z
| Categories | Mercedes-Benz Manuals, Mercedes-Benz R-Class Manuals |
|---|---|
| Tags | Mercedes Benz R350, Mercedes Benz R350 BlueTEC, Mercedes Benz V251 |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)