221_AKB;
d2ureepe,
5; 101, en-US
2009-05-15T09:42:33+02:00 - Seite 302
Version: 2.11.8.1
Wipers
302
Intermittent wiping
Single wipe
Only switch on intermittent wiping under wet X Press the combination switch briefly in
weather conditions or in the presence of
precipitation.
direction of arrowB to the resistance
point.
When you select intermittent wiping, the rain
sensor is activated. The rain sensor sets a
suitable wiping interval depending on the
The windshield wipers wipe one time
without washer fluid.
wetness of the sensor surface automatically. Wiping with washer fluid
!
Do not leave windshield wipers on an
X Press the combination switch in direction
of arrowB past the resistance point.
The windshield wipers operate with washer
fluid.
intermittent setting when the vehicle is
taken to an automatic car wash or during
windshield cleaning. Windshield wipers will
operate in the presence of water sprayed
on the windshield, and windshield wipers
may be damaged as a result.
i To prevent smears on the windshield or
noisy/chattering wiper blades, wipe with
washer fluid every now and then even when
it is raining.
For information on filling up the washer
reservoir, see “Washer system and headlamp
cleaning system” (Y page 405).
For information on cleaning the headlamps
with washer fluid, see “Headlamp cleaning
system” (Y page 299).
!
If you have set intermittent wiping, dirt on
the surface of the rain sensor or optical
effects may cause the windshield wipers to
wipe in an undesired fashion. This could
then damage the windshield wiper blades
or scratch the windshield. You should
therefore switch off the windshield wipers
when weather conditions are dry.
X Turn the combination switch to position
Ä orÅ.
Problems with wipers
After the initial wipe, pauses between
wipes are controlled by the rain sensor
automatically.
!
(leaves, snow, etc.), switch them off
immediately.
If anything blocks the windshield wipers
Intermittent wiping is interrupted when the
vehicle is at a standstill and a front door is
opened. This protects persons getting into or
out of the vehicle from being sprayed.
For safety reasons, do the following before
attempting to remove any blockage:
RStop the vehicle in a safe location.
RRemove the SmartKey from the starter
Intermittent wiping will be continued when all
doors are closed and
Rthe automatic transmission is in drive
position D or reverse gear R
switch.
or
RTurn off the engine by pressing the
KEYLESS-GO start/stop button and
open the driver’s door (with the driver’s
door open, starter switch is in position
or
Rthe wiper setting is changed using the
combination switch
0
, same as with SmartKey removed from
starter switch).
REngage the parking brake.
Product Specification
Categories | Mercedes-Benz Manuals, Mercedes-Benz S-Class Manuals |
---|---|
Tags | Mercedes-Benz S450, Mercedes-Benz S550, Mercedes-Benz S600, Mercedes-Benz S63 AMG, Mercedes-Benz S65 AMG, Mercedes-Benz W221 |
Model Year | 2010 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |