221_AKB;
d2ureepe,
5; 101, en-US
2009-05-15T09:42:33+02:00 - Seite 394
Version: 2.11.8.1
Useful features
394
Reprogramming a single signal
transmitter button
Programming tips
If you are having difficulty programming the
integrated remote control, here are some
To program a device using a signal
transmitter button previously trained, follow helpful tips:
these steps:
RCheck the frequency of hand-held remote
X Switch on the ignition.
controlA (typically located on the reverse
side of the remote). The integrated remote
control is compatible with radio-frequency
devices operating between 280-390 MHz.
X Press and hold the desired signal
transmitter button (;,= or?). Do not
release the button.
Indicator lamp: will begin to flash after
RPut a new battery in hand-held remote
controlA. This will increase the likelihood
of the hand-held remote control sending a
stronger and more accurate signal to the
integrated remote control.
20
seconds.
X Without releasing the signal transmitter
button, proceed with programming starting
with step 3.
RWhile performing step 3, hold hand-held
remote controlA at different lengths and
angles from the signal transmitter button
Operation of integrated remote control
X Switch on the ignition.
X Select and press the appropriate
integrated signal transmitter button (;,
(
;,= or?) you are programming.
Attempt varying angles at the distance of 2
to 12 inches (5 to 30 cm) away or the same
angle at varying distances.
=
or?) to activate the remote controlled
device.
RIf another hand-held remote control is
available for the same device, try the
programming steps again using that other
hand-held remote control. Make sure new
batteries are in the hand-held remote
control before beginning the procedure.
The integrated remote control transmitter
continues to send the signal as long as the
button is pressed – up to 20 seconds.
Erasing the integrated remote control
memory
RStraighten the antenna wire from the
garage door opener assembly. This may
help improve transmitting and/or receiving
signals.
i If you sell your vehicle, erase the codes of
all three channels.
X Switch on the ignition.
X Simultaneously press and hold outer signal
transmitter buttons; and?, for
approximately 20 seconds, until indicator
lamp: flashes rapidly. Do not hold for
longer than 30 seconds.
i Certain types of garage door openers are
incompatible with the integrated remote
control. If you should experience further
difficulties with programming the
integrated remote control, contact an
authorized Mercedes-Benz Center, or call
the Mercedes-Benz Customer Assistance
Center (USA only) at
The codes of all three channels are erased.
1-800-FOR-MERCedes,
or the HomeLink®
Hotline (USA only) at 1-800-355-3515, or
the Customer Service (Canada only) at
1-800-387-0100.
| Categories | Mercedes-Benz Manuals, Mercedes-Benz S-Class Manuals |
|---|---|
| Tags | Mercedes-Benz S450, Mercedes-Benz S550, Mercedes-Benz S600, Mercedes-Benz S63 AMG, Mercedes-Benz S65 AMG, Mercedes-Benz W221 |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)