221_AKB;
d2ureepe,
5; 101, en-US
2009-05-15T09:42:33+02:00 - Seite 454
Version: 2.11.8.1
Vehicle status messages in the multifunction display
454
Possible causes/consequences andX Solutions
Display messages
DISTRONIC - - - mph One of the activation conditions for the DISTRONIC PLUS has
PLUS
HOLD
not been fulfilled. You may have attempted to set a speed
below 20 mph (30 km/h).
X Drive faster than 20 mph (30 km/h) if the situation allows
and set the speed.
X Check the activation conditions for the DISTRONIC PLUS
(
Y page 331).
Off
The HOLD function switched off because the vehicle was
sliding, for example on a slippery surface.
X Activate the HOLD function later.
Blind
Spot
Assist
Currently
Unavailabl
e See
The Blind Spot Assist is deactivated because the area around
the sensors in the front or the rear bumper is dirty.
X Clean the front and rear bumper (Y page 438).
Oper.
Manual
The Blind Spot Assist is deactivated because the battery
voltage is insufficient.
X Have the battery checked at an authorized Mercedes-Benz
Center.
The Blind Spot Assist is switched off because the radar sensor
system is temporarily inoperative due to electromagnetic
interference near television and radio transmitter stations,
toll stations, speed measuring systems, etc.
X Wait until the message in the multifunction display
disappears.
Blind
Spot
Assist
Inoperativ
e
The Blind Spot Assist is malfunctioning.
X Contact an authorized Mercedes-Benz Center as soon as
possible.
| Categories | Mercedes-Benz Manuals, Mercedes-Benz S-Class Manuals |
|---|---|
| Tags | Mercedes-Benz S450, Mercedes-Benz S550, Mercedes-Benz S600, Mercedes-Benz S63 AMG, Mercedes-Benz S65 AMG, Mercedes-Benz W221 |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)