221_AKB;
d2ureepe,
5; 101, en-US
2009-05-15T09:42:33+02:00 - Seite 392
Version: 2.11.8.1
Useful features
392
transmitter buttons, do not repeat this step
and begin directly with step 3.
When programming a garage door opener,
park vehicle outside the garage.
X Step 3: Hold the end of hand-held remote
controlA of the device you wish to train
approximately 2 to 12 in (5 to 30 cm) away
from the signal transmitter button (;,=
or?) to be programmed, while keeping
indicator lamp: in view.
Do not run the engine while programming the
integrated remote control. Inhalation of
exhaust gas is hazardous to your health. All
exhaust gas contains carbon monoxide (CO),
and inhaling it can cause unconsciousness
and possible death.
X Step 4: Using both hands, simultaneously
press hand-held remote control buttonB
and the desired signal transmitter button
(
;,= or?). Do not release the buttons
until step 5 is completed.
Indicator lamp: will flash, first slowly and
then rapidly.
i Indicator lamp: flashes immediately
the first time the signal transmitter button
is programmed. If this button has already
been programmed, the indicator lamp will
start flashing after 20 seconds.
Interior rear view mirror with integrated remote
control
Hand-held remote controlA is not part of the X Step 5: After indicator lamp: changes
from a slow to a rapidly flashing light,
release the hand-held remote control
button and the signal transmitter button.
X Step 6: Press and hold the just-trained
signal transmitter button (;,= or?) and
observe indicator lamp:.
If indicator lamp: stays on constantly,
programming is complete and your device
should activate when the respective signal
transmitter button (;,= or?) is pressed
and released.
vehicle equipment.
Programming the integrated remote
control
X Step 1: Switch on the ignition.
X Step 2: If you have previously programmed
a signal transmitter button and wish to
retain its programming, proceed to step 3.
or
X If you are programming the integrated
remote control for the first time, press and
hold the two outer signal transmitter
buttons; and? and release them when
indicator lamp: begins to flash after
approximately 20 seconds.
i If indicator lamp: flashes rapidly for
approximately 2 seconds and then turns to
a constant light, continue with
programming steps 8 through 12 as your
garage door opener may be equipped with
the “rolling code” feature.
Do not hold the buttons for longer than
30
seconds.
X Step 7: To program the remaining two
signal transmitter buttons, repeat the steps
above starting with step 3.
This procedure erases any previous
settings for all three channels and
initializes the memory. If you later wish to
program a second and/or third hand-held
transmitter to the remaining two signal
| Categories | Mercedes-Benz Manuals, Mercedes-Benz S-Class Manuals |
|---|---|
| Tags | Mercedes-Benz S450, Mercedes-Benz S550, Mercedes-Benz S600, Mercedes-Benz S63 AMG, Mercedes-Benz S65 AMG, Mercedes-Benz W221 |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)