L
Gearbox
While in D, temporary Manual mode will be held
while the driver is accelerating, decelerating,
cornering or continuing to request shifts via the
paddles.
RANGE CHANGE INDICATORS
While the Hi range transmission is in use, no
range indicators are illuminated
In Lo range, the green warning lamp
in the message centre and the Lo
range status indicator lamp on the
Lo button will illuminate.
If continued use of temporary Manual mode (via
the shift paddles) is required, select S.
Temporary Manual mode will be automatically
deactivated if the engine is over-revved or
laboured, to prevent transmission and/or engine
damage.
While a range change is in progress, the
indicator lamps will flash as follows:
Manual gear selection will be accompanied by
the gearshift indicator. See 52, GEAR SHIFT
(GREEN).
Hi to Lo change:
•
The Lo range indicator lamps flash during
the change and then illuminate constantly.
•
The message LOW RANGE SELECTED is
briefly displayed in the message centre.
When the transmission is set to
permanent Manual mode (i.e. using the
paddles to change gear while in the S
position and Dynamic mode is selected,
see 134, DYNAMIC) transmission
up-shifts are fully controlled by the
driver. This means that the transmission
will not change up a gear automatically,
even when the vehicle's rev limit is
reached.
Lo to Hi change:
•
•
•
The Lo range indicator lamps flash during
the change.
The Lo range indicator lamps extinguish
when the change is complete.
The message HIGH RANGE SELECTED is
briefly displayed in the message centre.
RANGE CHANGING ON THE MOVE
HILL DESCENT
The recommended method of changing range
is with the vehicle stationary. For experienced
off-road drivers, a change from Lo to Hi while
on the move can be accomplished, as detailed
below.
With Hill Descent Control (HDC) selected in
either Drive (D), Sport (S) or manual gear
selection (CommandShift™) modes, a low gear
will be selected and maintained to provide
maximum engine braking. Should the selector
be moved to Drive (D) from the Sport (S) mode
or if CommandShift™ is deactivated, the
selected gear will be retained until the descent
is completed. See 135, HDC CONTROLS.
Note: Changing from Hi to Lo can be performed
only with the vehicle stationary.
CHANGING FROM LOW TO HIGH
RANGE
STATIONARY RANGE CHANGING
With the vehicle travelling no faster than
With the vehicle stationary and the engine
running, select Neutral (N).
60
km/h (38 mph), select Neutral (N). Press
and release the Lo button to select Hi range.
Press the Lo range button and release. The
range change status will be confirmed after
several seconds.
104
XML to PDF by RenderX XEP XSL-FO Formatter, visit us at http://www.renderx.com/
| Categories | Land Rover, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 2014, 2015 |
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Name | Range Rover Sport Handbook |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(4 votes, average: 4 out of 5)
Automotive readers have rated 2014-2015 Land Rover Range Rover Sport Handbook Manual 4.0 out of 5.0 based on 4 product reviews. very good and for the first time
I search for heat device control system
Excellent source. Easy to follow
good to finally getting manual from here