Windshield wipers
Windshield washers
(if equipped)
If the washer does not work, check
the washer fluid level. If the fluid level
is not sufficient, you will need to add
appropriate non-abrasive windshield
washer fluid to the washer reservoir.
Operates as follows when the igni-
tion switch is in the ON position.
nType A
MIST : For a single wiping cycle,
or MIST
move the lever to
The reservoir filler neck is located in
the front of the engine compartment
on the passenger side.
position and release. The
wipers will operate continu-
ously if the lever is held in this
position.
3
WARNING
OFF : Wiper is not in operation.
INT : Wiper operates intermittently at
the same wiping intervals. To
vary the speed setting, move
the speed control lever.
OGS045071L
When the outside temperature is
below freezing, ALWAYS warm the
windshield using the defroster to
prevent the washer fluid from freez-
ing on the windshield and obscur-
ing your vision which could result in
an accident and serious injury or
death.
nType B
i Information
If there is heavy accumulation of snow
or ice on the windshield, defrost the
windshield for about 10 minutes, or
until the snow and/or ice is removed
OGS045072L
before using the windshield wipers to In the OFF position, pull the lever
ensure proper operation.
gently toward you to spray washer
fluid on the windshield and to run the
wipers 1-3 cycles. Use this function
when the windshield is dirty. The
spray and wiper operation will contin-
ue until you release the lever.
If you do not remove the snow and/or
ice before using the wiper and washer,
it may damage the Wiper and washer
system.
3-82
| Categories | Hyundai Manuals, Hyundai Creta Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Creta |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)