ENGINE
Flywheel and starter ring gear - inspection
Starter ring gear - renew
1.
2.
3.
Inspect flywheel face for cracks, scores and
overheating. The flywheel can be refaced on
the clutch face providing thickness does not go
below minimum.
1.
Drill a 6 mm (0.250 in) diameter hole at root of
2
teeth.
Flywheel minimum thickness A = 40.45 mm
(1.6
in)
CAUTION: Do not allow drill to enter
flywheel.
Inspect starter ring gear for worn, chipped and
broken teeth.
2.
3.
Secure flywheel in soft jawed vice.
Split ring gear using a cold chisel.
CAUTION: Do not attempt to remove
reluctor ring.
WARNING: Wear safety goggles and take
precautions against flying fragments when
splitting ring gear.
Renew starter ring gear if necessary.
4.
Remove flywheel from vice, remove old ring
gear, and place flywheel, clutch side down, on
a flat surface.
34
OVERHAUL
| Categories | Land Rover, Land Rover Defender, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1999 |
| Download File |
|
| Product Name | Range Rover 4.0 & 4.6 Litre, Defender V8i |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)