Automatic Operation
You can switch from English to metric units through the
Driver Information Center (DIC). If you have the Base
audio system, see DIC Main Menu on page 3-57. If you
have the Navigation system, see “Setup Menu” in the
Index of the CTS/CTS-V Navigation System Owner
Manual.
AUTO (Automatic): When this button is pressed and
the temperature is set, the system will automatically
control the inside temperature, the air delivery mode,
the air conditioning compressor and the fan speed.
AUTO will appear on the display.
The air-conditioning system removes moisture from the
air, so you may sometimes notice a small amount of
water dripping underneath your vehicle while idling
or after turning off the engine. This is normal.
1.
2.
Press the AUTO button.
Adjust the temperature to a comfortable setting
between 70°F (21°C) and 80°F (27°C).
Choosing the coldest or warmest temperature
setting will not cause the system to heat or cool
any faster. If you set the system at the warmest
temperature setting, the system will remain in
manual mode at that temperature and it will not go
into automatic mode.
Do not cover the solar sensor located in the center of
the instrument panel, near the windshield. For more
information on the solar sensor, see “Sensors” later in
this section.
Manual Operation
In cold weather, the system will start at reduced fan
speeds to avoid blowing cold air into your vehicle
until warmer air is available. The system will
start out blowing air at the floor but may change
modes automatically as the vehicle warms up
to maintain the chosen temperature setting.
The length of time needed for warm up will depend
on the outside temperature and the length of time
that has elapsed since your vehicle was last driven.
yNz (Mode): Pressing the mode switch and
changing the mode cancels automatic operation and
places the system in manual mode. Press AUTO
to return to automatic operation.
The outboard air outlets will always receive airflow
regardless of the mode selected. See Outlet Adjustment
on page 3-28 to change this airflow from the outboard
outlets.
3.
Wait for the system to regulate. This may take from
10
to 30 minutes. Then adjust the temperature,
if necessary.
3-24
| Categories | Cadillac CTS Manuals, Cadillac Manuals |
|---|---|
| Tags | Cadillac CTS 2.8, Cadillac CTS 3.6, Cadillac CTS 6.0 |
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)