Fluid level checks
The brake fluid level should be between the
MIN and the MAX marks.
If the vehicle is operated in
temperatures below 4°C (40°F), use a
washer fluid with frost protection.
Note: The fluid level may drop slightly during
normal use as a result of brake pad wear, but
should not be allowed to drop below the MIN
mark.
Only use approved washer fluid.
Take care to avoid spillage, particularly
if an undiluted or high concentration is
being used. If spillage occurs, wash the
affected area immediately with water.
TOPPING UP THE BRAKE/CLUTCH
FLUID
Brake fluid will damage painted
surfaces. Soak up any spillage with an
absorbent cloth immediately and wash
the area with a mixture of car shampoo
and water.
TOPPING UP THE WASHER FLUID
The washer reservoir supplies the front and
rear screen washer jets and headlamp washer
jets.
Check and top-up the reservoir level at least
every week. Always top-up with screen washer
fluid to prevent freezing.
Only use new fluid from an airtight
container (fluid from open containers or
fluid previously bled from the system,
will have absorbed moisture, which will
adversely affect performance, and must
not be used).
Operate the washer switches periodically to
check that the nozzles are clear and properly
directed.
1.
Clean the filler cap before removing to
prevent dirt from entering the reservoir.
Top up the brake fluid with Shell DOT4
ESL brake fluid. If unavailable, use a
low viscosity, synthetic compatible
DOT4 brake fluid that meets ISO 4925
class 6 and Land Rover LRES22BF03
specification. Only fluid of this type and
standard may be used.
2. Remove filler cap.
3.
Top-up the reservoir until the fluid is visible
in the filler neck.
4.
Replace filler cap.
Do not top up the brake fluid to the
maximum mark unless the brake pads
have been replaced. If unsure, seek
qualified assistance.
BLOCKED WASHER JETS
Do not operate the washer jets during
unblocking or adjustment.
Windscreen washer fluid may cause
irritation to the eyes and skin. Always
read and observe the washer fluid
manufacturers instructions.
1.
Top up the reservoir to at least the
minimum mark.
2.
3.
Replace the reservoir cap.
Refit the reservoir cover.
If a washer jet becomes blocked, use a thin
strand of wire to unblock the jet by inserting
the wire into the jet. Ensure that the wire is
completely removed after unblocking.
WASHER FLUID CHECK
Do not allow screen washer fluid to
come into contact with naked flames
or sources of ignition.
182
| Categories | Land Rover, Land Rover Evoque |
|---|---|
| Tags | Land Rover |
| Model Year | 2011 |
| Download File |
|
| Language | Bulgarian, English |
| Product Name | Evoque Handbook |
| Product Brand | Land Rover |
| Applicable to Country | Bulgaria, International |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)