Garage door opener
5.
Press and hold the HomeLink opener
button and observe the indicator lamp.
REPROGRAMMING A SINGLE
GARAGE DOOR OPENER BUTTON
�
If the indicator is continuous,
programming is complete and your
device should operate when the
HomeLink opener button is pressed
and held for approximately 1 to 2
seconds and then released.
To programme a device to a previously
programmed button:
1.
2.
3.
Press and hold the desired
pre-programmed HomeLink button for at
least 20 seconds, but no longer than 30
seconds, until the indicator lamp begins to
flash.
�
If the indicator lamp blinks rapidly for
two seconds and then illuminates
continuously, proceed with the
following programming instructions
for rolling code device equipment.
Without releasing the button, position the
hand-held transmitter approximately 50 to
150 mm (2 to 6 inches) away from the
HomeLink transceiver, keeping the
indicator lamp in view.
ROLLING CODE DEVICE EQUIPMENT
PROGRAMMING
Carry out Step 3 of Programming.
Note: The assistance of a second person, may
make the following steps quicker and easier.
Once the button has been pressed there are
only 30 seconds in which to complete Step 3.
TO ERASE ALL PROGRAMMING
For first time programming, ensure that the
engine is switched off:
1.
Ensure that the ignition is on (but with the
engine switched off).
1.
At the garage door opener receiver (motor
head unit) in the garage, locate the learn or
smart button/switch.
2. Press and hold the two outer HomeLink
buttons. Keep the buttons pressed until the
indicator lamp begins to flash (this will take
approximately 20 seconds), then release
the buttons.
�
The name of the button or switch may
vary between manufacturers.
2.
3.
Press and release the learn or smart
button.
All memories in HomeLink have now been
cleared.
In your vehicle, firmly press the previously
programmed HomeLink opener button
twice and release.
Note: Do not perform this procedure when
programming the additional garage door
opener buttons.
4.
Press and hold briefly to complete the
programming process.
HomeLink should now activate the rolling code
device.
ENTRY GATE PROGRAMMING
The technology of some entry gates requires
you to press and re-press (cycle) the hand-held
transmitter button every two seconds during
programming.
54
| Categories | Land Rover, Land Rover Evoque |
|---|---|
| Tags | Land Rover |
| Model Year | 2011 |
| Download File |
|
| Language | Bulgarian, English |
| Product Name | Evoque Handbook |
| Product Brand | Land Rover |
| Applicable to Country | Bulgaria, International |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)