Tyre repair kit
10.
11.
Set the compressor switch to the on (l)
position.
19. Immediately drive the vehicle for 3 km (2
miles) to allow the sealant to coat the inner
surface of the tyre and form a seal at the
puncture.
Inflate the tyre to a minimum of 1.8 bar
(26
(51
lbf/in²) and a maximum of 3.5 bar
lbf/in²).
CHECKING THE TYRE PRESSURE
AFTER A REPAIR
�
When pumping the sealant through the
tyre valve, the pressure may rise up to
6
drop again after approximately 30
seconds.
bar (87 lbf/in²). The pressure will
When driving the vehicle, if you
experience vibrations, abnormal
steering, or noises, reduce speed
immediately. Drive with extreme
caution and reduced speed to the first
safe place to stop the vehicle. Visually
examine the tyre, and check its
pressure. If there are any signs of
damage or deformity to the tyre, or the
tyre pressure is below 1.3 bar
12.
During the inflation, switch the
compressor off briefly to check the tyre
pressure using the gauge mounted on the
compressor.
�
It should not take longer than seven
minutes to inflate the tyre. If after
seven minutes the tyre has not reached
the minimum pressure, the tyre should
not be used.
(19
lbf/in²), do not continue driving.
Consult a tyre repair centre, or your
Dealer/Authorised Repairer for advice
concerning the replacement of a tyre
after using a tyre repair kit.
13.
Once the tyre has been inflated, switch off
the compressor. If desired, the engine may
be turned off after the compressor has
been turned off.
1. Drive the vehicle for 3 km (2 miles) then
stop in a safe place. Carry out a visual
examination of the tyre’s condition.
14.
15.
Remove the power connector from the
auxiliary power socket.
2.
Remove the protective cap from the
inflation hose.
Remove the inflation hose from the tyre
valve by unscrewing it as quickly as
possible (anticlockwise).
3. Screw the inflation hose connector firmly
onto the tyre valve.
16.
17.
18.
Replace the inflation hose protective cap,
and the tyre valve cap.
4. Read the tyre pressure from the gauge.
Do not remove the sealant bottle from the
receiver.
5. If the pressure of the sealant filled tyre is
above 1.3 bar (19 lbf/in²) adjust the
pressure to the correct value.
Ensure that the tyre repair kit (including the
bottle, and receiver caps) are placed
securely in the vehicle. You will need to use
the kit to check the tyre pressure after 3 km
6. Ensure that the compressor switch is in the
off position (O), and insert the power cable
connector into an auxiliary power socket.
(2 miles) so ensure they are easily
accessible.
7.
If the vehicle is in a well ventilated area,
start the engine.
8.
Switch on the compressor (I), and inflate
the tyre to the correct pressure.
206
| Categories | Land Rover, Land Rover Evoque |
|---|---|
| Tags | Land Rover |
| Model Year | 2011 |
| Download File |
|
| Language | Bulgarian, English |
| Product Name | Evoque Handbook |
| Product Brand | Land Rover |
| Applicable to Country | Bulgaria, International |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)