Wheel changing
9.
Ensure that the space under the vehicle is
clear of obstructions and lower the vehicle
slowly and smoothly.
10.
With all wheels on the ground and the jack
removed, fully tighten the wheel nuts. The
wheel nuts must be tightened in sequence
(see illustration) to the correct torque of
133
Nm (98 lb.ft).
1.
Locate the jack under the relevant jacking
point.
Note: If it is not possible to torque the wheel
nuts when a wheel is replaced, they should be
set to the correct torque as soon as possible.
Note: Do not allow the jack to contact the
sill at any other point as damage may
result.
Check and adjust the tyre pressure as soon as
possible.
Note: The Sports pack sills include arrows
to identify jacking points.
2.
Attach the cranking lever to the jack using
the adaptor. Fit the wheel nut brace to the
end of the cranking lever.
3.
4.
5.
6.
Rotate clockwise to raise until the jack pin
locates into the jacking point.
Continue raising the vehicle until the wheel
is clear of the ground.
Remove the wheel nuts and place them
together where they cannot roll away.
Remove the wheel and place to one side.
Do not lay the wheel on its face, as this may
damage the finish.
7.
8.
Fit the temporary spare wheel to the hub.
Re-fit the wheel nuts and lightly tighten
them. Ensure that the wheel is making
contact with the hub evenly.
211
| Categories | Land Rover, Land Rover Evoque |
|---|---|
| Tags | Land Rover |
| Model Year | 2011 |
| Download File |
|
| Language | Bulgarian, English |
| Product Name | Evoque Handbook |
| Product Brand | Land Rover |
| Applicable to Country | Bulgaria, International |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)