EL(FL) UK 4B AUDIO.QXP 7/15/2013 10:21 AM Page 244
Features of your vehicle
VOICE RECOGNITION
Using Voice Recognition
If voice recognition is in [Normal Mode],
then the system will say “Please say a
command. Beep~”
5) If a name is not recognized from the
contact list, change it to a more
descriptive name (e.g., use “Grandpa
Joseph” instead of “Pa Joe”).
•
If voice recognition is in [Expert Mode],
then the system will only say a “Beep~”
Starting Voice Recognition
Shortly press the key on the steering
wheel remote controller Say a command
Skipping Prompt Messages
While prompt message is being stated
Shortly press the key on the steer-
ing wheel remote controller
•
To change the Normal Mode/Expert
SETUP
Mode setting, go to
[System]
[Prompt Feedback] / [Voice Recognition
System].
The prompt message is immediately
ended and the beep tone will sound.
After the “beep”, say the voice command.
✽
NOTICE
For proper recognition, say the com-
mand after the voice instruction and
beep tone.
Re-starting Voice Recognition
While system waits for a command
Shortly press the
ing wheel remote controller
key on the steer-
Contact List Best Practices
1)
Do not store single-name entries (e.g.,
“Bob”, “Mom”, “Kim”, etc.). Instead,
always use full names (including first
and last names) for all contacts (e.g.,
use “Jacob Stevenson” instead of
“Dad”).
The command wait state is immediately
ended and the beep ton will sound. After
the “beep”, say the voice command.
2)
3)
4)
Do not use abbreviations (i.e., use
“Lt.”
“Lieutenant”
instead
of
“Sergeant” instead of “Sgt.”).
or
Do not use acronyms (i.e., use
“County Finance Department” instead
of “CFD”).
Do not use special characters (e.g.,
“@”, “hyphen -“, “asterisk *”, amper-
sand &”).
4
244
| Categories | Hyundai Manuals, Hyundai ix35 Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, ix35 |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)