2014 Hyundai Ix35 Owners Manual

EL(FL) Eng 6.QXP  7/11/2013  10:52 AM  Page 6
What to do in an emergency
Jump starting procedure
2. If the booster battery is in another vehi-
cle, do not allow the vehicles to touch.
3. Turn  off   all   unnecessary   electrical
loads.
5. Start the engine of the vehicle with the
booster battery  and let it  run at 2,000
rpm, then start  the engine of the vehi-
cle with the discharged battery.
If the cause of your battery discharging is
not  apparent,  we  recommend  that  the
system  be   checked  by  an   authorized
HYUNDAI dealer.
CAUTION - AGM battery
(if equipped)
4.
Connect the jumper cables in the exact
sequence shown in the illustration. First
connect one end of a jumper cable to
the positive terminal of the discharged
battery (1), then connect the other end
to the positive terminal on the booster
battery (2). Proceed to connect one end
of the other jumper cable to the nega-
tive terminal of the booster battery (3),
then the other end to a solid, stationary,
metallic point (for example, the engine
lifting  bracket)  away  from  the  battery
Absorbent Glass Matt (AGM) bat-
teries  are  maintenance-free  and
we  recommend  that  the  system
be   serviced   by   an  authorized
HYUNDAI   dealer.  For   charging
your  AGM  battery, use  only  fully
automatic  battery  chargers   that
are specially  developed  for AGM
batteries.
Push-starting
Your manual  transaxle-equipped vehicle
should  not  be  push-started  because  it
might damage  the emission control sys-
tem.  Vehicles  equipped  with  automatic
transaxle cannot be push-started. Follow
the  directions  in  this  section  for  jump-
starting.
When replacing the AGM battery,
we recommend that you use parts
for  replacement  from  an  author-
ized HYUNDAI dealer.
(4).
Do not connect it to or near any part
that moves when the engine is cranked.
Do not allow the jumper cables to con-
tact anything except the correct battery
terminals or the correct ground.  Do not
lean over the battery when making con-
nections.
Do not open or remove the cap on
top of the battery.This may cause
leaks  of  internal  electrolyte  that
could result in severe injury.
WARNING
Never   tow  a   vehicle   to   start   it
because the sudden  surge forward
when the engine starts could cause
a collision with the tow vehicle.
If the AGM battery is reconnected
or replaced, ISG function will not
operate immediately.
CAUTION - Battery cables
If you want to use the ISG func-
tion, the battery sensor needs to
be calibrated for approximately 4
hours with the ignition off.
Do  not  connect   the  jumper  cable
from  the  negative   terminal  of  the
booster battery to the negative ter-
minal of the discharged battery.This
can cause the discharged battery to
overheat  and  crack,  releasing  bat-
tery acid.
1.
Make sure the booster battery is 12-volt
and that its negative terminal is ground-
ed.
6
6
Product Specification
Categories Hyundai Manuals, Hyundai ix35 Manuals
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 1534 pages
Document TypeOwners Manual
LanguageEnglish
Product BrandHyundai, ix35
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field