EL(FL) UK 7.QXP 8/5/2013 7:03 PM Page 41
Maintenance
Tread wear
5.
Maximum permissible inflation
pressure
WARNING - Tyre age
The tread wear grade is a compara-
tive rating based on the wear rate of
the tyre when tested under controlled
conditions on a specified govern-
ment test course. For example, a tyre
graded 150 would wear one-and-a-
half times (1½) as well on the gov-
ernment course as a tyre graded
100.
This number is the greatest amount
of air pressure that should be put in
the tyre. Do not exceed the maximum
permissible inflation pressure. Refer
to the Tyre and Loading Information
label for recommended inflation
pressure.
Tyres degrade over time, even
when they are not being used.
Regardless of the remaining
tread, it is recommended that
tyres generally be replaced
after six (6) years of normal
service. Heat caused by hot cli-
mates or frequent high loading
conditions can accelerate the
aging process. Failure to follow
this Warning can result in sud-
den tyre failure, which could
lead to a loss of control and an
6.
Maximum load rating
The relative performance of tyres
depends upon the actual conditions
of their use, however, and may
depart significantly from the norm
always use a tyre that has the same because of variations in driving
load rating as the factory installed habits, service practices and differ-
This number indicates the maximum
load in kilograms and pounds that
can be carried by the tyre. When
replacing the tyres on the vehicle,
accident involving
injury or death.
serious
tyre.
ences in road characteristics and cli-
mate.
7.
Uniform tyre quality grading
These grades are molded on the
4.
Tyre ply composition and material
Quality grades can be found where side-walls of passenger vehicle
applicable on the tyre sidewall tyres.The tyres available as standard
between tread shoulder and maxi- or optional equipment on your vehi-
The number of layers or plies of rub-
ber-coated fabric are in the tyre. Tyre
manufacturers also must indicate the
materials in the tyre, which include
steel, nylon, polyester, and others.
mum section width.
cles may vary with respect to grade.
For example:
The letter "R" means radial ply con- TREADWEAR 200
struction; the letter "D" means diago-
TRACTION AA
nal or bias ply construction; and the
letter "B" means belted-bias ply con-
struction.
TEMPERATURE A
7
41
| Categories | Hyundai Manuals, Hyundai ix35 Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, ix35 |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)