EL(FL) UK 6.QXP 8/5/2013 6:54 PM Page 29
What to do in an emergency
8.
With the engine start/stop button 9. Switch off the compressor.
position on or ignition switch posi-
Distributing the sealant
10.
Detach the hoses from the 11. Immediately drive approximately
tion on, switch on the compressor
and let it run for approximately 5~7
minutes to fill the sealant up to
proper pressure. (refer to the Tyre
and Wheels, chapter 8). The infla-
tion pressure of the tyre after filling
sealant bottle connector and
from the tyre valve.
4~6 miles (7~10 km or, about
10min) to evenly distribute the
sealant in the tyre.
Return the TyreMobilityKit to its stor-
age location in the vehicle.
CAUTION
is
checked/corrected later.
unimportant
and
will
be
WARNING - Carbon
monoxide
Do not exceed a speed of 80
km/h (50 mph). If possible, do
not fall below a speed of 20
km/h (12 mph).
Be careful not to overinflate the
tyre and stay away from the tyre
when filling it.
Do not leave your vehicle run-
ning in a poorly ventilated area
for extended periods of time.
Carbon monoxide poisoning
and suffocation can occur.
Whilst driving, if you experience
any unusual vibration, ride dis-
turbance or noise, reduce your
speed and drive with caution
until you can safely pull off of
the side of the road.
CAUTION - Tyre pressure
Do not attempt to drive your
vehicle if the tyre pressure is
below 200kpa(29 PSI).
This
Call for road side service or tow-
ing. When you use the Tyre
Mobility Kit, the tyre pressure
sensors and wheel may be dam-
aged by sealant, remove the
sealant stained with tyre pres-
sure sensors and wheel and
inspect in authorized dealer.
could result in an accident due
to sudden tyre failure.
6
29
| Categories | Hyundai Manuals, Hyundai ix35 Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, ix35 |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)