MAINTAINING YOUR VEHICLE
253
Follow These Steps To Repla ce The Carpet :
WARN ING!
1.
Place the front floor carp ets in the vehicle.
Only rem ove the carp et for clean ing purposes. It
provid es insulation again st high floor pan tem pera-
tures. You or you r passen gers could be burned if the
carp et is not prop erly in place. Alw ays put the carp et
back into the veh icle before drivin g.
2. Attach the carp et to the stu ds in the footw ell and press
on the attachm ent caps to secure the carp et.
3.
to front floor carp et.
Place rear floor carp et in vehicle and snap rear carp et
4.
carp et.
Install wheelhou se carp et follow ed by the cargo floor
Follow These Steps To Remove The Carpet :
1.
located on the outboard side of each front seat.
Unsnap the front and rear floor carp ets. A snap is
5.
Reinstall Add-A-Trunk™ if so equ ipped.
Seat Belt Main ten ance
Do not bleach, dye or clean the belts with chem ical 7
solvents or abrasive cleaners. This will weaken the fabric.
Sun damage will also weaken the fabric.
2.
area on both the driver and passenger side. The cap is
rem oved by pulling it straight out.
Remove the attachm ent cap from the front footw ell
3.
4.
Remove the front and rear floor carp ets.
If the belts need cleaning, use a mild soap solu tion or
lukew arm water. Do not rem ove the belts from the
vehicle to wash them .
Remove the cargo floor and wheelhou se carp ets.
NOTE: If your vehicle is equipped with an Add-A-
Trunk™ it must be removed to be able to remove the cargo
floor and wheelhou se carpets. For Add-A-Trunk™ removal
procedure, refer to “Storage” in Section 3 of this manual.
Replace the belts if they appear frayed or worn or if the
buckles do not work prop erly.
| Categories | Jeep Manuals, Jeep Wrangler Manuals |
|---|---|
| Model Year | 2004 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)