68
Instruments and controls
Resetting values
To reset the values, press CLR for at least
four seconds.
The following functions will be reset
simultaneously:
CHECK messages
The following CHECK messages may be
displayed:
When the engineis started, CHECKING will
appear on the display for about four sec-
onds, while the SID checks are being per-
formed.
When a CHECK message is generated
while the car is being driven, a chime will
sound, INFO DISPL will illuminate on the
main instrument panel, and the message
will appear on the SID. The number of mes-
sages that can be displayed by the SID
varies with the specification of the car.
If more than one CHECK message has
been generated, the+ symbol willappear to
the left of the text on the display. The mes-
sages appear in order of priority.
If a new fault occurs whileanother message
is being displayed, the message relating to
the new one will appear for 10 seconds,
after which the display will return to the ear-
lier one.
Display shows:
See
page
TEST BRAKE LIGHTS 1)
BRAKE LIGHT FAILURE
FRONT LIGHT FAILURE
REAR LIGHT FAILURE
FOG LIGHT FAILURE
183
•
Estimated range on remaining fuel
183
181
183
184
180
138
174
39
(function based on a fuel consumption of
28
mpg)
•
•
•
Average fuel consumption
Average speed
Arrival time (function based on current
speed)
WASHER FLUID LEVEL LOW
TIGHTEN FUEL FILLER CAP
FILL COOLANT FLUID
KEY NOT ACCEPTED
Programmed values for DIST, ALARM and
SPD W will not be reset (see the respective
function).
REPLACE KEY BATTERY
SERVICE THEFT ALARM
39
39
TRANSMISSION OVERHEAT-
ING
144
Press CLR once to acknowledge a mes-
sage, whereupon it will be cleared from the
display. It will not be displayed again before
the ignition has been switched off and then
on again.
TIME FOR SERVICE 2)
212
1 This message cannot be removed by pressing
CLR. Press the brake pedal to clear.
2 This message will be displayed approximately
600
miles (1,000 km) before the next sched-
uled service is due, or when 365 days have
elapsed since the last service. The message
should be cleared at the time of that service
(see the Saab Warranties & Service Record
Booklet).
If you have carried out the service yourself, you
can clear the message by pressing CLR once.
Reset by pressing CLR for at least eight sec-
onds, until ”SERVICE” appears on the display
and a chime sounds.
| Categories | Saab 9-3 Manuals, Saab Manuals |
|---|---|
| Tags | Saab 9-3 M2000 |
| Model Year | 2000 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)