2000 Saab 9-3 Owners Manual

88
Instruments and controls
Useful tips:
ACC - 9-3 Convertible
When the soft top is folded down the ACC
system goes over to manual temperature
setting.
Between HI and LO there are eleven (0-10)
fixed temperature steps.
If the ACC system is not functioning
satisfactorily the following should be tried
before you take the car to an authorized
Saab dealer.
If the indication AUTO does not light up
after starting (the ignition must have been
switched off for at least 10 minutes): See
Cancelling programming of ACC.
The system adjusts itself as follows
AUTO is turned off.
Heating,airdistributionandfanspeedare
not affected.
ACC display with soft top folded down
If you think that the ACC system is not
functioning satisfactorily you should:
Recirculation and electric rear window
are turned off.
A/C assumes the same setting (ON/OFF)
as it had when the soft top was last folded
down.
1.
Check that the cigarette lighter plug is
in its socket (since if the socket is empty
heated air can flow out and affect the
cabin sensor).
2.
Recalibrate: See the section headed
Calibration.
All manual selections are possible with the
exception of electric rear window.
Saab recommends leaving the ACC setting
on ECON when the soft top is folded down
to improve fuel economy and unnecessary
running of the A/C compressor.
If the battery has been disconnected or
has died, the ACC system shouldbe reca-
librated: See Calibration.
Programmed settings are not deleted if the
battery has been disconnected.
When the soft top is raised the system
reverts to the AUTO mode and the previous
set temperature.
Extinguishing the lighting in ACC
See section Night Panel, page 63.
Product Specification
CategoriesSaab 9-3 Manuals, Saab Manuals
Tags
Model Year2000
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 236 pages
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field