2002 Hyundai Atos Owners Manual

DO-IT-YOURSELF MAINTENANCE
G290B02X-GAT
SPECIFICATIONS:
Vertical aiming
Adjustment After Headlight Assembly
Replacement
"H"
Horizontal  center  line  of  headlights  from
ground : 646 mm (25.43 in.)
3
Horizontal line
0mm(1.18in.)
Vertical
line
W
15mm
(0.59in.)
"W"
Distance between each headlight center:
"P"
988
"L"
mm (38.89 in.)
H
Cut-off line
Distance between  the  headlights and  the
wall that the lights are tested against:
3,000 mm (118 in.).
G290A02Y
Ground line
4.
Clean the head light lenses and turn on the
headlights (Low beam).
Open the hood.
Draw the vertical line (through the center of
each headlight beam pattern) and the hori-
zontal line (through the center of each head-
light beam pattern) on the aiming screen.
L
H
G290B01Y
5.
6.
If the vehicle has had front body repair and the
headlight  assembly  has  been  replaced,  the
headlight aiming should be checked using the
aiming screen as shown in the illustration. Turn
on the headlight switch. (Low Beam Position)
And then, draw the horizontal parallel line at
30 mm (1.18 in.) under the horizontal line.
1.
Adjust headlights so that main axis of light is
parallel  to center  line  of the  body  and is
aligned with point "P" shown in the illustra-
tion.
Dotted lines in the illustration show the cen-
ter of headlights.
7.
8.
Adjust each cut-off line  of the low beam to
the parallel line with a phillips screwdriver -
VERTICAL AIMING.
Adjust each cut-off line  of the low beam to
the each vertical line  with a phillips screw-
driver - HORIZONTAL AIMING.
2.
6-18
Product Specification
Categories Hyundai Manuals, Hyundai Atos Manuals
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 249 pages
Document TypeOwners Manual
LanguageEnglish
Product BrandHyundai, Atos
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field