Controls in detail
Useful features
Step 3:
Step 5:
Rolling code programming
̈
Hold the end of the hand-held remote
control 5 of the device you wish to
train approximately 2 to 5 in
̈ After indicator lamp 1 changes from a
slow to a rapidly flashing light, release
the hand-held remote control button
and the signal transmitter button.
To train a garage door opener (or other
rolling code devices) with the rolling code
feature, follow these instructions after
completing the “Programming” portion
(steps 1 through 6) of this text. (A second
person may make the following training
procedures quicker and easier.)
(5
to12 cm) away from the signal trans-
mitter button (2, 3 or 4) to be pro-
grammed, while keeping indicator
lamp 1 in view.
Step 6:
̈
Press and hold the just-trained signal
transmitter button (2, 3 or 4) and
observe indicator lamp 1.
Step 4:
Step 8:
̈
Using both hands, simultaneously
̈ Locate “training” button on the garage
door opener motor head unit.
If indicator lamp 1 stays on
constantly, programming is complete
and your device should activate when
the respective signal transmitter
button (2, 3 or 4) is pressed and
released.
press hand-held remote control
button 6 and the desired signal trans-
mitter button (2, 3 or 4). Do not
release the buttons until step 5 is com-
pleted.
Exact location and color of the button
may vary by garage door opener brand.
Depending on manufacturer, the
“training” button may also be referred
to as “learn”or “smart” button. If there
is difficulty locating the transmitting
button, refer to the garage door opener
Operator’s Manual.
Indicator lamp 1 will flash, first slowly
and then rapidly.
i If indicator lamp 1 flashes rapidly for about
seconds and then turns to a constant light,
continue with programming steps 8 through 12
as your garage door opener may be equipped
with the “rolling code” feature.
2
i Indicator lamp 1 flashes immediately the
first time the signal transmitter button is
programmed. If this button has already been
programmed, the indicator lamp will only start
flashing after 20 seconds.
୴୴
Step 7:
̈
To program the remaining two signal
transmitter buttons, repeat the steps
above starting with step 3.
331
| Categories | Mercedes-Benz Manuals, Mercedes-Benz R-Class Manuals |
|---|---|
| Tags | Mercedes Benz R350, Mercedes Benz V251, Mercedes-Benz R320 |
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)