Useful features
315
Rolling code programming
Gate operator/Canadian programming
To train a garage door opener (or other rolling Canadian radio-frequency laws require
code devices) with the rolling code feature, transmitter signals to “time-out” (or quit)
follow these instructions after completing the after several seconds of transmission which
“Programming” portion (steps 1 through 6) of may not be long enough for the integrated
this text. For your convenience and to
complete the procedure faster, you might
want to have someone assist you.
signal transmitter to pick up the signal during
programming. Similar to this Canadian law,
some U.S. gate operators are designed to
“time-out” in the same manner.
X Step 8: Locate the “training” button on the
garage door opener motor head unit.
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4 with
the following:
i Exact location and color of the button may
vary by garage door opener brand.
Depending on manufacturer, the “training”
button may also be referred to as “learn” or
“smart” button. If there is difficulty locating X Step 4: Press and hold the signal
the transmitting button, refer to the garage
door opener Operator’s Manual.
transmitter button (;,= or?). Do not
release this button until it has been
successfully trained.
X While still holding down the signal
transmitter button (;,= or?), “cycle”
your hand-held remote control buttonB
as follows: Press and hold buttonB for
X Step 9: Press the “training” button on the
garage door opener motor head unit.
The “training light” is activated.
You have 30 seconds to initiate the
following two steps.
X Step 10: Return to the vehicle and firmly
press, hold for 2 seconds and release the
programmed signal transmitter button (;,
2
seconds, then release it for 2 seconds,
and again press and hold it for 2 seconds.
Repeat this sequence on the hand-held
remote control until the frequency signal
has been learned.
Upon successful training, indicator
lamp: will flash slowly and then rapidly
after several seconds.
=
or?).
X Step 11: Press, hold for 2 seconds and
release same signal transmitter button a
second time to complete the training
process.
X Proceed with programming step 5 and
step 6 to complete.
i Some garage door openers (or other
rolling code equipped devices) may require
you to press, hold for 2 seconds and
release the same signal transmitter button
a third time to complete the training
process.
i Upon completion of programming the
integrated remote control, make sure you
retain the hand-held remote control that
came with the garage door opener, gate
operator or other device. You may need it
for use in other vehicles, for future
programming of an integrated remote
control, or simply for continued use as a
hand-held remote control to operate the
respective device in other situations.
X Step 12: Confirm the garage door
operation by pressing the programmed
signal transmitter button (;,= or?).
X Step 13: To program the remaining two
signal transmitter buttons, repeat the steps
above starting with step 3.
Z
| Categories | Mercedes-Benz Manuals, Mercedes-Benz SLS-Class Manuals |
|---|---|
| Tags | Mercedes Benz C197 |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)