Useful features
316
Reprogramming a single signal
transmitter button
side of the remote). The integrated remote
control is compatible with radio-frequency
devices operating between 280-390 MHz.
RPut a new battery in hand-held remote
controlA. This will increase the likelihood
of the hand-held remote control sending a
stronger and more accurate signal to the
integrated remote control.
To program a device using a signal
transmitter button previously trained, follow
these steps:
X Switch on the ignition.
X Press and hold the desired signal
transmitter button (;,= or?). Do not
release the button.
RWhile performing step 3, hold hand-held
remote controlA at different lengths and
angles from the signal transmitter button
Indicator lamp: will begin to flash after
20
seconds.
(
;,= or?) you are programming.
X Without releasing the signal transmitter
button, proceed with programming starting
with step 3.
Attempt varying angles at the distance of 2
to 12 inches (5 to 30 cm) away or the same
angle at varying distances.
RIf another hand-held remote control is
available for the same device, try the
programming steps again using that other
hand-held remote control. Make sure new
batteries are in the hand-held remote
control before beginning the procedure.
RStraighten the antenna wire from the
garage door opener assembly. This may
help improve transmitting and/or receiving
signals.
Operation of integrated remote control
X Switch on the ignition.
X Select and press the appropriate
integrated signal transmitter button (;,
=
or?) to activate the remote controlled
device.
The integrated remote control transmitter
continues to send the signal as long as the
button is pressed – up to 20 seconds.
i Certain types of garage door openers are
incompatible with the integrated remote
control. If you should experience further
difficulties with programming the
integrated remote control, contact an
authorized Mercedes-Benz Center, or call
the Mercedes-Benz Customer Assistance
Center (USA only) at
Erasing the integrated remote control
memory
i If you sell your vehicle, erase the codes of
all three channels.
X Switch on the ignition.
X Simultaneously press and hold outer signal
transmitter buttons; and?, for
approximately 20 seconds, until indicator
lamp: flashes rapidly. Do not hold for
longer than 30 seconds.
1-800-FOR-MERCedes
(1-800-367-6372),
or the HomeLink® Hotline (USA only) at
or the Customer Service
(Canada only) at 1-800-387-0100.
1-800-355-3515,
The codes of all three channels are erased. i USA only:
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
Programming tips
If you are having difficulty programming the
integrated remote control, here are some
helpful tips:
1.
This device may not cause harmful
interference, and
RCheck the frequency of hand-held remote
controlA (typically located on the reverse
| Categories | Mercedes-Benz Manuals, Mercedes-Benz SLS-Class Manuals |
|---|---|
| Tags | Mercedes Benz C197 |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)