Tires and wheels
332
Restarting Advanced TPMS
G Warning!
It is the driver’s responsibility to set the tire
inflation pressure to the recommended cold
tire inflation pressure. Underinflated tires
affect the ability to steer or brake the vehicle.
You might lose control over the vehicle.
X Press button9 or: on the
multifunction steering wheel to select
Tire Pressure.
X Press buttona.
The current inflation pressure for each tire
appears in the multifunction display or the
following message appears in the
multifunction display:
When you restart the TPMS, the system sets
new reference values for each tire.
Tire pressures
will be displayed
after driving
a few minutes
level (e.g. because of different load or driving X Press button:.
The TPMS must be restarted when you have
adjusted the tire inflation pressure to a new
conditions). The TPMS is then recalibrated to
the current tire inflation pressures.
The following message appears in the
multifunction display:
Use Current
i Canada only:
Pressures as New
Reference Values
Press 'OK' to Confirm
X Press buttona.
The following message appears in the
multifunction display:
Tire Press. Monitor
Restarted
After driving a few minutes the system
verifies that the current tire inflation
pressures are within the system’s specified
range. Afterwards the current tire inflation
pressures are accepted as reference values
and then monitored.
The TPMS usually recognizes tire pressure
adjustments and sets new reference values
automatically. You can, however, restart
the TPMS manually as described.
Restart the TPMS after adjusting the tire
inflation pressure to the inflation pressure
recommended for the vehicle operating
condition. Tire inflation pressure should only
be adjusted on cold tires. Observe the
recommended tire inflation pressure on the
Tire and Loading Information placard on the
driver’s door B-pillar. Some vehicles may have
supplemental tire inflation pressure
information for driving at high speeds or for
vehicle loads less than the maximum loaded X If you wish to cancel: Press button%.
vehicle condition. If such information is
provided, it can be found on the inside of the
fuel filler flap.
or
X Press button9 to exit the menu screen.
i When the wheel positions have been
changed, the inflation pressure of a tire
may be displayed for the wrong position
temporarily. After driving for a few minutes,
the inflation pressure will be shown for the
correct position.
X Using the Tire and Loading Information
placard on the driver’s door B-pillar
(
Y page 334) or the supplemental tire
inflation pressure information on the inside
of the fuel filler flap, make sure the tire
inflation pressure of all four tires is correct.
X Switch on the ignition.
X Press button= or; on the
multifunction steering wheel to select the
Service menu.
| Categories | Mercedes-Benz Manuals, Mercedes-Benz SLS-Class Manuals |
|---|---|
| Tags | Mercedes Benz C197 |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)