150
UNDERSTANDINGTHEFEATURESOFYOURVEHICLE
garage door opener’s Owner’s Manual. Finally, repro-
gram the hand-held transmitter(s) to HomeLink using
thestepsunder
؆
ProgrammingHomeLink؆
.PressandholdtheHomeLinkbuttonwhileyoupress
andrelease-everytwoseconds(
؆
cycle؆
)yourhand-heldtransmitter button until the radio signal has success-
fully been accepted by HomeLink. (The message
TRAINEDwillappearontheHomeLinkdisplay.)
GateOperator/CanadianProgramming
Canadian radio-frequency laws require transmitter sig-
nals to Љtime-outЉ (or quit) after several seconds of
transmission - which may not be long enough for
HomeLink to pick up the signal during programming.
SimilartothisCanadianlaw,someU.S.gateoperatorsare
designedtoЉtime-outЉinthesamemanner.
Proceed with the remaining steps under ЉProgramming
HomeLinkЉtocomplete.
UsingHomeLink
To operate, simply press and release the programmed
HomeLink button. Activation will now occur for the
trained device (i.e. garage door opener, gate operator,
security system, entry door lock, home/office lighting,
etc.). For convenience, the hand-held transmitter of the
device may also be used at any time. In the event that
there are still programming difficulties or questions,
contactHomeLinkat:www.homelink.comor1-800-355-
If you live in Canada or you are having difficulties
programming a gate operator by using the ЉProgram-
ming HomeLinkЉ procedures (regardless of where you
live),replacesteptwowiththefollowing:
NOTE: If programming a garage door opener or gate
operator, it is advised to unplug the device during the
ЉcyclingЉprocesstopreventpossibleoverheating.
3515.
| Categories | Jeep Liberty Manuals, Jeep Manuals |
|---|---|
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)