DO-IT-YOURSELFMAINTENANCE
6
35
G290B01JM-GAT
Adjustment After Headlight
Assembly Replacement
If the vehicle has had front body
repair and the headlight assembly
has been replaced, the headlight aim-
ing should be checked using an aim-
ing screen as shown in the illustra-
tion. Turn on the headlight switch.
(Low Beam Position)
Vertical
aiming
Horizontal
aiming
Left-Hand Drive
Vertical
line
30 mm
Horizontal line
W
15 mm
"P"
1.
Adjust headlights so that main axis
of light is parallel to center line of
the body and is aligned with point
"P" shown in the illustration.
H
Cut-off
line
L
G290A01JM
Ground
line
5.
6.
Open the hood.
2. Dotted lines in the illustration show
the center of headlights.
Draw the vertical line (through the
center of each headlight) and the
horizontal line (through the center
of each headlight) on the aiming
screen.
G290B01Y
Right-Hand Drive
Vertical line
Horizontal line
W
"P"
And then, draw a parallel line at 30
mm (1.18 in.) under the horizontal
line.
30 mm
15
mm
H
Cut-off line
L
7.
8.
Adjust each cut-off line of the low
beam to the parallel line with a
phillips screwdriver - VERTICAL
AIMING.
Ground
line
H
Adjust each cut-off line of the low
beam to each vertical line with a
phillips screwdriver - HORIZON-
TAL AIMING.
G290B01L-D
Jmgene-6.p65
35
4/13/04, 4:25 PM
| Categories | Hyundai Manuals, Hyundai Tucson Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Tucson |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)