OWNERMAINTENANCE 6
REPLACING LIGHT BULBS
33
G290B01JM-EAT
Adjustment After Headlight As-
sembly Replacement
1. Adjust headlights so that main axis
of light is parallel to center line of
the body and is aligned with point
"P" shown in the illustration.
G260A03A-EAT
In the event of bulb failure being
experienced, ensure that the relative
lighting circuit is turned off prior to
attempting to replace the bulb. The
illustrations on the following page will
assist in locating and removing the
various bulbs. Ensure that the re-
placement bulb has the same cap
configuration and wattage as the origi-
nal.
Right-Hand Drive
Vertical line
2.
Dotted lines in the illustration show
the centre of headlights.
Horizontal line
W
"P"
30
mm
1
5 mm
SPECIFICATIONS:
"H";
Horizontal centre line of headlights
from ground: 35.6 in. (904 mm)
H
Cut-off line
L
Ground
line
See page 6-40 for the wattage de-
scriptions.
"W";
Distance between each headlight
centre: 53.4 in. (1,356 mm)
H
G290B01L-D
!
If the vehicle has had front body
repair and the headlight assembly
has been replaced, the headlight aim-
ing should be checked using the aim-
ing screen as shown in the illustra-
tion. Turn on the headlight switch
(Low Beam Position).
CAUTION:
"L";
Keep the lamps out of contact with
petroleum products, such as oil,
gasoline, etc.
Distance between the headlights
and the wall that the lights are
tested against:
118
in. (3,000 mm).
jmuk-6.p65
33
5/31/04, 4:49 PM
| Categories | Hyundai Manuals, Hyundai Tucson Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Tucson |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)