6 OWNER MAINTENANCE
34
And then, draw a parallel line at 1.50
in. (38 mm) under the horizontal line in
case of adjusting the low beam or at
G290B01HP-EAT
Adjustment After Headlight As-
sembly Replacement
shown in the illustration. Turn on the
headlight switch (Low Beam or High
Beam Position).
0.83 in. (21 mm) under the horizontal
line in case of adjusting the high beam.
<Low Beam>
1.5 in.(38 mm)
Horizontal line
1. Adjust headlights so that main axis
of light is parallel to centre line of
the body and is aligned with point
"P" shown in the illustration.
2. Dotted lines in the illustration show
the centre of headlights.
Vertical line
W
7
. Adjust each cut-off line of the low
beam to the parallel line with a
phillips screwdriver - VERTICAL
AIMING.
"P"
H
Cut-off line
8.
Adjust each cut-off line of the low
beam to the each vertical line with
a phillips screwdriver - HORIZON-
TAL AIMING.
"H"
Horizontal centre line of headlights
from ground :
L
Ground
line
H
G290B01HP-D
Low Beam : 35.1 in. (894 mm)
High Beam : 33 in. (839 mm)
<High Beam>
Vertical
line
Horizontal line
1.54 in.(39 mm)
"W"
Distance between each headlight
centre :
Low Beam : 51.8 in. (1,316 mm)
High Beam : 42.4n. (1,076 mm)
W
"P"
0.83 in.
(21mm)
H
Cut-off line
L
Ground
line
"L"
H
Distance between the headlights
and the wall that the lights are
tested against :
G290B02HP-E
If the vehicle has had front body repair
and the headlight assembly has been
replaced, the headlight aiming should
be checked using an aiming screen as
Low Beam : 118.1 in. (3,000 mm)
High Beam : 118.1in. (3,000 mm)
| Categories | Hyundai Manuals, Hyundai Terracan Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Terracan |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)