Controls in detail
Control system
୴
୴̈ Press button j or k repeatedly
until the message Compass setting
Zone appears in the multifunction
display.
Compass calibration
̈ Press button j or k repeatedly
until the message
Compass Calibration appears in the
multifunction display.
i Make sure you are in area where you can
drive a full circle with your vehicle without dis-
turbing traffic in order to calibrate the compass.
The selection marker is on the current
setting.
The selection marker is on setting
switched off.
This function is not available if your vehicle
is equipped with the COMAND system and
navigation module*.
In order to calibrate the compass properly,
mind the following:
ț
Calibrate the compass in open terrain.
Nearby buildings, bridges, power lines
and large antenna masts, for example,
could impair compass calibration.
̈
Press button æ or ç to set the
respective compass zone.
̈ Press button æ to set the selection
marker to Start.
ț
Switch off electrical consumers (e.g.
climate control, windshield wipers, or
rear window defroster).
For information on how to call up the
compass, see “Compass” (୴ page 345).
The following message appears in the
multifunction display:
Compass Calibration active
Please drive in a full circle
ț
Close all doors and the tailgate.
̈
̈
Start the engine (୴ page 57).
Press button æ or ç to move
the selection marker to the Vehicle
submenu.
182
| Categories | Mercedes-Benz GL-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz GL320 CDI, Mercedes-Benz GL450, Mercedes-Benz X164 |
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)