Practical hints
Flat tire
̈
Position jack 3 under the take-up
bracket 2 so that it is always vertical
(plumb-line) as seen from the side,
even if the vehicle is parked on an in-
cline.
2
3
4
Take-up bracket
Jack
Crank
1
Wheel wrench
̈
On wheel to be changed, loosen but do
not yet remove the wheel bolts
(approximately one full turn with wheel ! Vehicles with factory-mounted
wrench 1).
running-boards*:
̈
Turn crank 4 clockwise until jack 3
is fully seated in take-up bracket 2
and the jack base evenly meets the
ground.
Your vehicle is equipped with a scissors-type
jack (located under the cargo compartment
floor) designed for use with factory-mounted
running boards. Only use this jack when jacking
up vehicles with factory-mounted running boards
as otherwise the vehicle’s underbody can be
damaged. See separate instructions for
scissors-type jack.
The jack take-up brackets are located di-
rectly behind the front wheel housings and
in front of the rear wheel housings.
!
Do not position the jack on the body of the
vehicle, as this may cause damage to the
vehicle.
̈ Continue to turn crank 4 until the
wheel is a maximum of 1.2 in (3 cm)
from the ground.
୴୴
̈
Place jack 3 on firm ground.
525
| Categories | Mercedes-Benz GL-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz GL320 CDI, Mercedes-Benz GL450, Mercedes-Benz X164 |
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)