Controls in detail
Useful features
Step 4:
Operation of integrated remote control
i Upon completion of programming the inte-
grated remote control, make sure you retain the
hand-held remote control that came with the ga-
̈
Press and hold the signal transmitter
̈ Switch on the ignition (୴ page 42).
button (2, 3 or 4). Do not release
this button until it has been successful-
ly trained.
rage door opener, gate operator or other device. ̈ Select and press the appropriate inte-
You may need it for use in other vehicles, for fu-
ture programming of an integrated remote con-
trol, or simply for continued use as a hand-held
remote control to operate the respective device
in other situations.
grated signal transmitter button (2,
or 4) to activate the remote con-
3
̈
While still holding down the signal
transmitter button (2, 3 or 4),
“cycle” your hand-held remote control
button 6 as follows: Press and hold
button 6 for 2 seconds, then release
it for 2 seconds, and again press and
hold it for 2 seconds. Repeat this se-
quence on the hand-held remote con-
trol until the frequency signal has been
learned. Upon successful training,
indicator lamp 1 will flash slowly and
then rapidly after several seconds.
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
Reprogramming a single signal trans-
mitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
Erasing the integrated remote control
memory
̈
̈
Switch on the ignition (୴ page 42).
̈
̈
Switch on the ignition (୴ page 42).
Simultaneously press and hold outer
signal transmitter buttons 2 and 4,
for approximately 20 seconds, until
indicator lamp 1 flashes rapidly. Do
not hold for longer than 30 seconds.
Press and hold the desired signal
transmitter button (2, 3 or 4).
Do not release the button.
̈
Proceed with programming step 5 and
step 6 to complete.
̈
Indicator lamp 1 will begin to flash af-
ter 20 seconds. Without releasing the
signal transmitter button, proceed with
programming starting with step 3.
The codes of all three channels are
erased.
i If you sell your vehicle, erase the codes of all
three channels.
343
| Categories | Mercedes-Benz GL-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz GL320 CDI, Mercedes-Benz GL450, Mercedes-Benz X164 |
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)