X164_AKB; 4; 51, en-US
d2ureepe,
2009-03-23T09:27:13+01:00 - Seite 221
Version: 2.11.8.1
Useful features
221
If you live in Canada or if you are having
X Switch on the ignition.
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4 with
the following:
X Press and hold the desired signal
transmitter button (;,= or?). Do not
release the button.
Indicator lamp: will begin to flash after
X Step 4: Press and hold the signal
transmitter button (;,= or?). Do not
release this button until it has been
successfully trained.
20 seconds.
X Without releasing the signal transmitter
button, proceed with programming starting
with step 3.
X While still holding down the signal
transmitter button (;,= or?), “cycle”
your hand-held remote control buttonB
as follows: Press and hold buttonB for
Operation of integrated remote control
X Switch on the ignition.
X Select and press the appropriate
integrated signal transmitter button (;,
= or?) to activate the remote controlled
device.
The integrated remote control transmitter
continues to send the signal as long as the
button is pressed – up to 20 seconds.
2
seconds, then release it for 2 seconds,
and again press and hold it for 2 seconds.
Repeat this sequence on the hand-held
remote control until the frequency signal
has been learned.
Upon successful training, indicator
lamp: will flash slowly and then rapidly
after several seconds.
X Proceed with programming step 5 and
step 6 to complete.
Erasing the integrated remote control
memory
i Upon completion of programming the
integrated remote control, make sure you
retain the hand-held remote control that
came with the garage door opener, gate
operator or other device. You may need it
for use in other vehicles, for future
programming of an integrated remote
control, or simply for continued use as a
hand-held remote control to operate the
respective device in other situations.
i If you sell your vehicle, erase the codes of
all three channels.
X Switch on the ignition.
X Simultaneously press and hold outer signal
transmitter buttons; and?, for
approximately 20 seconds, until indicator
lamp: flashes rapidly. Do not hold for
longer than 30 seconds.
The codes of all three channels are erased.
Reprogramming a single signal
transmitter button
Programming tips
If you are having difficulty programming the
integrated remote control, here are some
To program a device using a signal
transmitter button previously trained, follow helpful tips:
these steps:
RCheck the frequency of hand-held remote
controlA (typically located on the reverse
side of the remote). The integrated remote
Z
| Categories | Mercedes-Benz GL-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz GL350 BlueTEC, Mercedes-Benz GL450, Mercedes-Benz GL500, Mercedes-Benz GL550, Mercedes-Benz X164 |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(3 votes, average: 4.33 out of 5)
Automotive readers have rated 2010 Mercedes-Benz GL350 BlueTEC GL450 GL500 GL550 X164 Owners Manual 4.3 out of 5.0 based on 3 product reviews.