X164_AKB; 4; 51, en-US
d2ureepe,
2009-03-23T09:27:13+01:00 - Seite 341
Version: 2.11.8.1
Flat tire
341
For information on where to find the
respective items, see “Where will I find ...?”
Y page 284) and (Y page 286).
Make sure that the ground on which the
vehicle is standing and where you place the
jack is solid, level and not slippery. If
(
necessary, use a large underlay. On slippery
surfaces, such as tiled floors, you should use
a non-slip underlay, for example a rubber mat.
i Vehicles without spare wheel are not
factory-equipped with the tools required for
a wheel change such as a jack or a wheel
wrench. Some tools required for a wheel
change are specific to your vehicle.
Contact an authorized Mercedes-Benz
Center to obtain the tools approved for
your vehicle. This section describes the
wheel change using the tools approved and
recommended for your vehicle.
Do not use wooden blocks or similar objects
to support the jack. Otherwise the jack may
not be able to achieve its load-bearing
capacity if it is not at its full height.
Never start the engine when the vehicle is
raised.
Also observe the notes on the jack.
Lifting the vehicle
G Warning!
X Prevent the vehicle from rolling away by
blocking wheels with wheel chocks or other
sizeable objects.
When your vehicle is equipped with a wheel
chock, it is included with the vehicle tool kit
When jacking up the vehicle, only use the jack
which has been specifically approved by
Mercedes-Benz for your vehicle.
(
the collapsible wheel chock, see
Y page 284). For information on setting up
The jack is designed exclusively for jacking up
the vehicle at the jack take-up brackets built
into both sides of the vehicle. Make sure the
jack arm is fully seated in the jack take-up
bracket. The jack must always be vertical
when in use, especially on inclines or
declines.
(Y page 286).
G Warning!
Only jack up the vehicle on level ground or on
slight inclines/declines. Otherwise, the
vehicle could fall off the jack and injure you or
others.
The jack is intended only for lifting the vehicle
briefly for wheel changes. It is not suited for
performing maintenance work under the
vehicle. To help avoid personal injury, use the
jack only to lift the vehicle during a wheel
change.
Changing a wheel on a level surface
Never get beneath the vehicle while it is
supported by the jack. Keep hands and feet
away from the area under the lifted vehicle.
Always lower the vehicle onto sufficient
capacity jackstands before working under the
vehicle.
Always engage the parking brake firmly and
block the wheels with wheel chocks or other
sizeable objects before raising the vehicle
with the jack. Do not disengage the parking
brake while the vehicle is raised.
Changing rear wheel on passenger side (example
illustration)
X Place a wheel chock or other sizeable
object in front of and another wheel chock
or other sizeable object behind the wheel
Z
| Categories | Mercedes-Benz GL-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz GL350 BlueTEC, Mercedes-Benz GL450, Mercedes-Benz GL500, Mercedes-Benz GL550, Mercedes-Benz X164 |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(3 votes, average: 4.33 out of 5)
Automotive readers have rated 2010 Mercedes-Benz GL350 BlueTEC GL450 GL500 GL550 X164 Owners Manual 4.3 out of 5.0 based on 3 product reviews.